Rubber Mallets

Provide a gentle but firm blow with little rebound. Solid wooden self locking handles. The mallets are available in a range of sizes and grades of rubber to meet specific requirements.

Standard

All purpose mallet used widely for automotive, industrial, DIY and camping etc.

Thor Soft Faced Hammers

A safer alternative for striking machined surfaces than conventional steel hammers. The impact resistant striking faces shape themselves to the component being struck, minimising rebound damage to the component and reducing noise pollution in the work place. The striking faces can be easily replaced once they have become worn. Available as standard, with a choice of 5 interchangeable face types:

Rawhide Face

Head manufactured from malleable iron fitted with two rawhide striking faces and solid wooden handle. Rawhide manufactured from genuine water buffalo hide, tightly coiled and pressed three times under powerful hydraulic presses to ensure uniform quality and maximum durability.

Thor Soft Faced Hammers

A safer alternative for striking machined surfaces than conventional steel hammers. The impact resistant striking faces shape themselves to the component being struck, minimising rebound damage to the component and reducing noise pollution in the work place. The striking faces can be easily replaced once they have become worn. Available as standard, with a choice of 5 interchangeable face types:

Plastic Face

Malleable iron head, fitted with two white high molecular weight polythene striking faces for high impact applications.

Super Plastic Mallets

High molecular weight polythene mallet heads, suitable for high impact applications. With solid wooden shafts. Heads resistant to abrasion, corrosion and most chemicals.

(Bossing) Pear Shaped

Kennedy Club Hammers

Kennedy Club or lump hammers have fully forged and heat-treated hammer heads with flat striking faces and chamfered edges.

They are suitable for use with cold chisels, brick bolsters, star drills and masonry nails in confined work areas with little room for a full arc swing, the wide face makes it ideal for striking chisels and punches.

Available in a range of weights with hickory or fibreglass shafts.

Hickory Shaft

With fine grain, forged steel head, hardened and tempered with polished faces.

Sledge Hammers

Double faced sledge hammers are fully forged and heat-treated. Ideal for use on spikes, stakes, cold chisels and hardened nails. They are available with a hickory or fibreglass shaft.

Fibreglass Shaft BS 876

Dampens the impact transmitted to the user's hand and wrist. The high strength of the shaft and head bond make the hammer virtually unbreakable. Tested to the requirements of BS 876: 1981 (head stamped BS 876).

Super Plastic Mallets

High molecular weight polythene mallet heads, suitable for high impact applications. With solid wooden shafts. Heads resistant to abrasion, corrosion and most chemicals.

(Tinmens) Cylindrical

Spare Striking Faces For Thor Hammers

Easy to change, simply screw in. The striking faces are colour coded to allow easy identification of material type and hardness.

Brown

Tough polyurethane shore D58-62. Abrasive resistant suitable for striking sharp surfaces.

Thor Soft Faced Hammers

A safer alternative for striking machined surfaces than conventional steel hammers. The impact resistant striking faces shape themselves to the component being struck, minimising rebound damage to the component and reducing noise pollution in the work place. The striking faces can be easily replaced once they have become worn. Available as standard, with a choice of 5 interchangeable face types:

Aluminium Face

Malleable iron head fitted with solid shaft and two ductile aluminium faces.

Spare Striking Faces For Thor Hammers

Easy to change, simply screw in. The striking faces are colour coded to allow easy identification of material type and hardness.

White

Hard nylon shore D61-65. All purpose face suitable for light and heavy duty applications.