Socket Head Countersunk Screws

Manufactured from stainless steel to prevent rusting or where high temperatures are a consideration. Dimensions to BS EN ISO 4762 DIN 912.

Metric Sizes - A2 Stainless Steel

Socket Set Screws

High tensile alloy steel. Grade 14.9. BS 2470. For quick and permanent location of pulleys, collars and gears on shafts. Will hold fast even in poorly tapped holes. Interrupted profile of clamping face resists loosening due to vibration. Sizes above 1/4? are generally counterbored to provide maximum clamping efficiency.

Inch (BSW) - Knurled Cup Point - Self Colour

A2 Stainless Steel - Button Head

A2 Stainless Steel - Button Head

Washers

Bright Zinc plated. Single coil square section spring washers. DIN 7980.

Metric

N.B. Priced Individually - Standard Box Quantity = 100 Pieces

High Tensile Hexagon Head Bolts

BS1768. Grade S.

Inch (UNF) - Self Colour

Socket Set Screws

High tensile alloy steel. Grade 14.9. BS 2470. For quick and permanent location of pulleys, collars and gears on shafts. Will hold fast even in poorly tapped holes. Interrupted profile of clamping face resists loosening due to vibration. Sizes above 1/4? are generally counterbored to provide maximum clamping efficiency.

Inch (BSF) - Knurled Cup Point - Self Colour

Rawlplug Concrete Screwbolt

Screw bolt for fixing in to masonry substrates, a high performance, heavy duty anchor which cuts it's own thread. A non-expansion fixing suitable for use near substrate edge where expanding products would damage the structure. Single piece design including forged Hex Head and Washer no assembly required before installation. Suitable Base Materials: wood, masonry (brick), concrete (cracked and non cracked).
Features and benefits;
High performance bolt using undercut technology.
Quick and easy installation.
Close edge and spacing distance installation parameters.
Removable and reusable.
Low expansion force in base material.

Kennedy Professional Threading Inserts

Kennedy Professional Thread Repair Wire Inserts are the easiest and quickest inserts to install to repair damaged or worn threads, you simply screw the insert into the pre-drilled and tapped hole, until the drive tang breaks off. They can be used with plastics or other materials provided that the material is strong enough to withstand the expansion of the insert as the screw thread locks into the wall of the hole. They are also suitable for new applications where, because of their mechanical strength benefits their introduction may result in the use of thinner sections or lighter parent materials without sacrificing thread strength they can also be used for converting from metric to inch and vice versa.

Most inserts are 1.5x diameter for length. For example:- M6 is 9mm long.
Other lengths are available on request.

Available in Metric, UNC, UNF, BSF, BSP and BSW sizes.

For all dimensional specifications please refer to our catalogue.

Wire Threading Inserts (Metric)

Available in packs of 10 and 50.

Socket Head Cap Screws

Manufactured from stainless steel to prevent rusting or where high temperatures are a consideration. Dimensions to BS EN ISO 4762 DIN 912.

Metric Sizes - A2 Stainless Steel

Kennedy Extractable Dowels

Extractable dowel pins complete with inner thread and slight flats for air release. DIN 7979D. EN 28735. ISO 8735. Material: AISI-52100 or DIN 1-3505 100 Cr 6. Hardness: 57-63 HRC.