Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 2.0-20.
(D)33mm x (L)40mm.

ER32

Granlund Size 1 Pilots

Type R Roller. c9.

When working ?dry? type R roller pilots must be lubricated. Pilots type RS must be combined with holders type AS.

For all technical specifications please refer to our catalogue.

Pinzbohr Micro Heads

Used in combination with indexable insert I.S.O. boring bars, these units can produce bores down to 5.5mm diameter and up to 34mm diameter. These MICRO heads fit the standard Pinzbohr arbors with connection diameters (SD') of 27, 32 or 42mm. Graduated precision dial readout to 0.01mm.

Note: If ground inserts used, please specify left hand for boring. Bores as small as 5.5mm diameter can be produced by using stepped bars.

For all dimensional specifications please refer to our catalogue.

Indexa-Seiki? QMC 06 Quad Milling Holder Set

Small diameter Indexable End Mills that take a CCMT 06 insert. Ideal for use on manual and CNC milling machines where reach and clearance are required. Uses CCMT inserts.

PSC and PSCa (adjustable) Collets for Plain Shank Cutters

Tru-Loc Collets are available for plain shank cutters in two different styles, PSC non adjustable and PSCa - Collets with an adjustable back-stop screw to allow more accurate & consistent cutter replacement.

For all dimensional specifications please refer to our catalogue.

PSC Type

Indexa-Seiki ER Single-Angle Collets

Collet Dimensions:
Capacity 3.0-13.
(D)21mm x (L)31.5mm.

ER20

Granlund HSS Size 1 Countersinks

Type T. HSS. Tolerance x9 90.

Countersink T with a diameter 50mm and larger are made with a driving lip. These sizes should be used in the appropriate type M holder.

For further specifications please refer to our catalogue.

Granlund HSS Size 1 Counterbores

Type NA. HSS. Tolerence P8.

Counterbores NA with a diameter of 50mm and larger are all made with a driving lip. These sizes should be used in the appropriate type M toolholder.

For further specifications please refer to our catalogue.

PSC and PSCa (adjustable) Collets for Plain Shank Cutters

Tru-Loc Collets are available for plain shank cutters in two different styles, PSC non adjustable and PSCa - Collets with an adjustable back-stop screw to allow more accurate & consistent cutter replacement.

For all dimensional specifications please refer to our catalogue.

PSC Type

Granlund Size 1 Insert Drills

Type LB HSS Tol. h8 flute 40mm.

When combining insert drills with countersinks, the drill must break through the work piece before secondary cutting commences and must not be used for blind holes.

For all technical specifications please refer to our catalogue.