Indexa-Seiki FM - Face Mill Adaptors

From an extensive programme of quality spindle nose tooling, used with an extensive range of face and shell mills

Indexa-Seiki Tapping Collets

Slipping clutch type. To suit Indexa-Seiki tension and compression type tapping chucks.

For all technical specifications please refer to our catalogue.

DIN SZ1

Indexa-Seiki Tapping Collets

Rigid type. To suit Indexa-Seiki Rigid type tapping chucks.

For all dimensional and technical specifications please refer to our catalogue.

DIN SZ1

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 0.5-10.
(D)17mm x (L)27mm.

ER16

Indexa-Seiki Tapping Collets

Slipping clutch type. To suit Indexa-Seiki tension and compression type tapping chucks.

For all technical specifications please refer to our catalogue.

DIN SZ2

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 3.0-26.
(D)41mm x (L)46mm.

ER40

Indexa-Seiki Standard Pull Studs

BT-MAS 403

Indexa-Seiki VDI Toolholders

Manufactured to DIN 69880. Suitable for use in NC lathes with VDI fixing disc. Features: All tools are fully carburised and hardened. Surface hardness of 58 - 60HRC. Tensile strength above 1000N/mm2. Surfaces blued; seat, parallel shank and shoulder ground. Tools can be adjusted in-situ on radial and axial toolholders. Seat shim allows two tool sizes to be used with one toolholder. Ball regulator (bullseye) provides easy coolant control.

AR3026 Parting-Off Holder

Indexa-Seiki XP Range

A new generation of Indexa Seiki? 'XtraPlasma' indexable weldon end mills and shell mills with plasma ion coating and through coolant. A 90 approach angle for profiling, slotting and face milling. Plasma ion coating offers a longer tool life and greater hardness that is more resistant to wear.

80mm Shell Mill

XP-90C Weldon End Mills

Positive 90 approach milling cutter, using size 10/16 inserts allowing depth passes and high feed per teeth. Torx screw allows for good chip ecacuation. Plasma Ion coating offers longer tool life and greater hardness that is more resistant to wear. Through coolant as standard.

XP-90C End Mills For AP_T 10 Inserts