Adapter Sleeves

Adaptor sleeves are commonly used for locating tapererd bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjuction with SNR feeler gauges accurate radial clearances will be achieved.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

SNR Shaft Seals & Adaptors

The SNR SC...SV series consists of a contact washer made of corrosion-protected steel with a vulcanised rubber lip to locate in the housing.

The V-Ring seal has axial contact after being fitted to the shaft with the face of the washer. If the shaft extends through the housing one seal pack must be
ordered for both side of the housing.

Other sealing arrangements are available through your local service branch.

Pillow Block V-Ring Seals

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Bolt Flanged Unit - SFT Type - Two Bolt

Cast iron self lube units with bolt holes.

SNR Pillow Block Housings

The housings are produced from grey cast iron in compliance with DIN EN 1561 and external surface painted RAL 5010 - Gentian Blue) the machined surfaces are treated with an anti-corrosion agent. Threaded for grease nipple or automatic lubrication and grease drain hole which is sealed with a metal threaded plug at the factory but can be removed subject to application.
Housings based on ISO 113/II: 1994 and DIN 736: 1984 to DIN 739: 1984.

500 Series for use with tapered bore from 1200K, 2200K, 22200K and 23200K with shaft diameter: 20mm to 140mm. 600 Series for use with tapered bore from 1300K, 3200K, 21300K and 22300K with shaft diameter: 20mm to 90mm.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

Hook Spanners

SNR Hook spanners enable the safe and effortless tightening and loosening of all KM, KML and KMK type locknuts and avoid damage to the nuts or shaft.

Manufactured from tempered steel, these spanners are extremely strong and robust.

SNR Shaft Seals & Adaptors

Adapter sleeves are commonly used for locating tapered bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjunction with SNR feeler gauges accurate radial clearances will be achieved.

Adaptor Sleeves