Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Plummer Blocks - Medium Series - NP Type

Cast iron self lube unit plummer blocks. Medium series.
With two slotted holes for fixing.

SNR Shaft Seals & Adaptors

The SNR SC...SV series consists of a contact washer made of corrosion-protected steel with a vulcanised rubber lip to locate in the housing.

The V-Ring seal has axial contact after being fitted to the shaft with the face of the washer. If the shaft extends through the housing one seal pack must be
ordered for both side of the housing.

Other sealing arrangements are available through your local service branch.

Pillow Block V-Ring Seals

SNR Shaft Seals & Adaptors

Cover plates are made of corrosion-resistant steel and used where the shaft terminates inside the housing. In this configuration only one seal set will be required.

Cover Plates

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Plummer Blocks - Light Series - SL Type

Cast iron self lube unit plummer blocks.
Light series. With two slotted holes for fixing.

Adapter Sleeves

Adaptor sleeves are commonly used for locating tapererd bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjuction with SNR feeler gauges accurate radial clearances will be achieved.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

Hook Spanners

SNR Hook spanners enable the safe and effortless tightening and loosening of all KM, KML and KMK type locknuts and avoid damage to the nuts or shaft.

Manufactured from tempered steel, these spanners are extremely strong and robust.

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Flanged Housing Unit - MSF Type Square - Four Bolt

Made of grey cast iron with four fixing holes.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.