Welders Chipping Hammers

Scaling and chipping hammers. For boiler scaling, weld dressing etc

Welder's Chipping hammer

Manufactured from tempered & hardened steel, chisel & point striking faces with close grain hardwood handle.

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hickory Shaft

With fine grain, forged steel head, hardened and tempered with polished faces.

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hardwood Shaft

With fine grain, forged steel head, hardened and tempered with polished faces.

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hickory BS 876 Shaft

Tested to the requirements of BS 876: 1981 (head stamped BS 876).

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hickory Shaft

With fine grain, forged steel head, hardened and tempered with polished faces.

Shrinking Hammers

Highly polished striking heads and cheeks. One flat round face and one milled, serrated square face. Hickory shaft. Manufactured to BS 4114. Specially designed for panel beating on slightly stretched areas of metal. The cross milled face forces small amounts of metal into the spaces created.

Kennedy Carpenters Claw Hammers

Manufactured from high-grade drop forged steel, fully heat-treated, with the claw being shaped in a continuous curve and tapered to grip the nail firmly.

Fibreglass Shaft

With textured slip resistant rubber grip. Shaft and grip combine to dampen the impact transmitted through to the user's hand and wrist. Reduces operator fatigue and the risk of RSI (repetitive strain injury). The high strength of the shaft and head bond make the hammer virtually unbreakable.

Cross Pein Hammers

Traditionally used by joiners and fitters. Cross pein can be used for setting pins and nails prior to "driving home" with the flat faced pein.

Warrington Hardwood Shaft

Close grained hardwood shaft shaped to comfortably fit in the hand. Forged steel head with ground and polished striking face.

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hickory BS 876 Shaft

Tested to the requirements of BS 876: 1981 (head stamped BS 876).

Kennedy Club Hammers

Kennedy Club or lump hammers have fully forged and heat-treated hammer heads with flat striking faces and chamfered edges.

They are suitable for use with cold chisels, brick bolsters, star drills and masonry nails in confined work areas with little room for a full arc swing, the wide face makes it ideal for striking chisels and punches.

Available in a range of weights with hickory or fibreglass shafts.

Club Hammer with Fibreglass Shaft

Kennedy Club hammers with a fibre glass shaft have a textured slip resistant rubber grip. The shaft & grip combine to dampen the impact transmitted through to the user"s hand and wrist.