CNMG Indexable Turning Inserts

T7020 (ISO P20-P35 M20-M30) CVD Coated. Turning grade with multi-layer coating incorporating an Aluminium oxide layer to allow high cutting speeds to be employed. Use on low, medium and high Carbon Steels and Stainless Steels.

Tungaloy TCMT Indexable Turning Inserts

T9025 (ISO P20-P30, M20-M30) MT-CVD Coated. Increased wear resistance provided by the new "Double-Bridge" coating technology allowing for higher cutting conditions. Universal grade for medium to rough turning of steel at medium speed. 24-Medium operation chipbreaker.

CNMG Indexable Turning Inserts

AH120 (ISO K10 - K20) TiALN PVD coated for roughing super alloys and stainless steels.

TNMG Indexable Turning Inserts

T9025 (ISO P20-P30, M20-M30) MT-CVD Coated. Increased wear resistance provided by the new "Double-Bridge" coating technology allowing for higher cutting conditions. Universal grade for medium to rough turning of steel at medium speed.TM-Medium operation chipbreaker.

VCMT Indexable Turning Inserts

NS530/NS540 (ISO P05-P20) A finishing grade for steel and stainless steel. Gives a superior and consistent surface finish.

Tungaloy CCMT Indexable Turning Inserts

T9025 (ISO P20-P30, M20-M30)A finishing and medium cut for steels and stainless steel. Gives superior and consistent surface finish

Tungaloy CCMT Indexable Turning Inserts

T9025 (ISO P20-P30, M20-M30)A finishing and medium cut for steels and stainless steel. Gives superior and consistent surface finish

WNMG Indexable Turning Inserts

T6030 (ISO M20-M40) CVD coated. Having a high heat resistance and good adhesion between coating layer and substrate, favourable chemical and mechanical properties allows for maximum process reliability and efficiency. Used for continuous and interrupted cutting of extremely difficult to cut Mo-enriched Stainless Steel, Austenites, Austenite-Ferrite, Duplex and Cast Stainless Steel with a high Mo content.

CNMG Indexable Turning Inserts

T9025 (ISO P20-P30, M20-M30) MT-CVD Coated. Increased wear resistance provided by the new "Double-Bridge" coating technology allowing for higher cutting conditions. Universal grade for medium to rough turning of steel at medium speed.TH-Roughing chipbreaker.

CNMG Indexable Turning Inserts

GH330 (ISO P20-P35 M25-M40) A finishing grade for steels and stainless steels.