Bosch Style Chisels

Suitable for air and electric hammers and breakers, for all classes of work.



For Bosch: USH27, USH28, 11304, 11308, 12314. 29mm Hex Shank with Single Flat.

Kennedy® M2 Multi-Tooth Milling Cutters

Proven value and success based upon the low energy required to cut more holes accurately with extended tool life. The cutter is designed to enable a faster feed rate with lower cutting resistance, resulting in consistency of finish and tolerance.

Short Series

Shank dia.: 19mm/3/4".
Depth of cut: 25mm.
Bore: 6mm.
Overall length: 60mm.

Kennedy® Router Cutters

With ball bearing guide. Tool will produce an ovolo mould to window frames, sashes and glazing bars. Cabinet doors and frames, trophy plaques/plinths, shelves, etc. Self guiding with ball bearing.

Two Flute Beading Bits

Kennedy® M2 Multi-Tooth Milling Cutters

Proven value and success based upon the low energy required to cut more holes accurately with extended tool life. The cutter is designed to enable a faster feed rate with lower cutting resistance, resulting in consistency of finish and tolerance.

Long Series

Shank dia.: 19mm/3/4".
Depth of cut: 50mm.
Bore: 6mm.
Overall length: 85mm.

Kennedy® "Ultimate" Merino Sheepskin Bonnets

Genuine 100% sheepskin tie-on bonnets ideal for polishing metal, glass fibre, wood and painted surfaces. With tie cord. 32mm pile. Maximum 2,500rpm - Best results are obtained with a tool speed of 1,500 - 2,000rpm. Not suitable for wet use. Support pad supplied separately.

Kennedy® Router Cutters

For panel mould on cabinet and drawer fronts. 1/4" shank diameter.

2 Flute Standard Ogee Bit

Kennedy® Wire Wheels & Brushes

Industrial rotary wire wheels & brushes are available as a comprehensive range including circular brushes, shaft mounted arbor style and de-carbonising brushes for use with power tools, machine tools and flexible drives.

Cup Brushes - Shaft Mounted

For all round use, ideal for work on larger surfaces removing burrs, rust and paint. 6mm Shanks. 30 SWG.

Kennedy® M2 Multi-Tooth Milling Cutters

For use with all multi-tooth milling cutters with 6mm bore. Pilots locate into pre-drilled pilot holes ensuring positional accuracy of the cutter. Suitable for "blind" or "through" pilot holes, pin will retract into cutter adaptor on "bottoming".

Pilot Pins

Bore diameter: 20mm.
Overall length: 156mm.

Kennedy® Router Cutters

With ball bearing guide. For producing a rebate to a wide variety of components including picture, door and window frames. With ball bearing guide ensuring accurate depth of cut, eliminating the need for jigs and fixtures. Ideal for straight, curved and shaped work.

Two Flute Rabbeting Bits

Kennedy® Router Cutters

With Ball Bearing Guide. To trim laminate producing a bevelled edge. With ball bearing guide suitable for straight or shaped work.

Bevel Edge Trimming Bits