Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Adapter Sleeves

Adaptor sleeves are commonly used for locating tapererd bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjuction with SNR feeler gauges accurate radial clearances will be achieved.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

SNR Shaft Seals & Adaptors

Adapter sleeves are commonly used for locating tapered bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjunction with SNR feeler gauges accurate radial clearances will be achieved.

Adaptor Sleeves

Hook Spanners

SNR Hook spanners enable the safe and effortless tightening and loosening of all KM, KML and KMK type locknuts and avoid damage to the nuts or shaft.

Manufactured from tempered steel, these spanners are extremely strong and robust.

Adapter Sleeves

Adaptor sleeves are commonly used for locating tapererd bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjuction with SNR feeler gauges accurate radial clearances will be achieved.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

SNR Shaft Seals & Adaptors

Cover plates are made of corrosion-resistant steel and used where the shaft terminates inside the housing. In this configuration only one seal set will be required.

Cover Plates

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Flanged Housing Unit - MFC Type Round - Four Bolt

Made of grey cast iron with four fixing holes.