Adapter Sleeves

Adaptor sleeves are commonly used for locating tapererd bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjuction with SNR feeler gauges accurate radial clearances will be achieved.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

SNR Pillow Block Housings

The housings are produced from grey cast iron in compliance with DIN EN 1561 and external surface painted RAL 5010 - Gentian Blue) the machined surfaces are treated with an anti-corrosion agent. Threaded for grease nipple or automatic lubrication and grease drain hole which is sealed with a metal threaded plug at the factory but can be removed subject to application.
Housings based on ISO 113/II: 1994 and DIN 736: 1984 to DIN 739: 1984.

500 Series for use with tapered bore from 1200K, 2200K, 22200K and 23200K with shaft diameter: 20mm to 140mm. 600 Series for use with tapered bore from 1300K, 3200K, 21300K and 22300K with shaft diameter: 20mm to 90mm.

SNR Shaft Seals & Adaptors

SNC bearing housings can be used for both fixed and floating bearing arrangements. Locating rings enable the bearing to be fixed in place axially. The width of the locating rings is adapted to the bearing being used. To secure the bearings, two locating rings per housing are required.

Locating Rings

SNR Shaft Seals & Adaptors

SNC bearing housings can be used for both fixed and floating bearing arrangements. Locating rings enable the bearing to be fixed in place axially. The width of the locating rings is adapted to the bearing being used. To secure the bearings, two locating rings per housing are required.

Locating Rings

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

Lock Nuts

Used primarily to help lock and locate bearings on shafts or adaptor sleeves. They have evenly spaced slots on the circumference for use with the SNR range of hook spanners.

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Flanged Housing Unit - MSF Type Square - Four Bolt

Made of grey cast iron with four fixing holes.

SNR Shaft Seals & Adaptors

Cover plates are made of corrosion-resistant steel and used where the shaft terminates inside the housing. In this configuration only one seal set will be required.

Cover Plates

SNR Shaft Seals & Adaptors

Adapter sleeves are commonly used for locating tapered bored bearing and securing them to a shaft. They can be accurately positioned and dismounted. By using in conjunction with SNR feeler gauges accurate radial clearances will be achieved.

Adaptor Sleeves