Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Fibreglass Shaft

With textured slip resistant rubber grip. Shaft and grip combine to dampen the impact transmitted through to the user's hand & wrist. Reduces operator fatigue and the risk of RSI (Repetitive Strain Injury). The high strength of the shaft and head bond make the hammer virtually unbreakable.

Rubber Mallets

Soft faced for use where steel hammers would mark the surface.

Hickory Shaft.

Kennedy Ball Pein Hammers

Ball Pein hammers are manufactured from high-grade drop forged steel fully heat-treated. Ideal for use with cold chisels, punches, rivets and for the shaping of metal.

Hickory BS 876 Shaft

Tested to the requirements of BS 876: 1981 (head stamped BS 876).

Finishing Picks

Highly polished striking heads and cheeks. With crowned faces. Will remove low spots when metal finishing. Hardwood shaft and finishing beater. Manufactured to BS 4114.

Curved Pein Panel Beater

Medium weight for general use where access is difficult.

Solid Copper Mallet

Manufactured from 99.9% pure electrolytic copper rod. These mallets provide a firm positive blow without the risk of damage to expensive components. Ideal for positive blows on highly finished or closely ground machined parts throughout the aircraft, automotive or shipping industries. Also used by tool and gauge makers.

Tubular Steel Shaft Claw

The head is securely fixed in place by \tinterference fit onto a chrome plated tubular steel shaft. With non-slip, shock absorbing flock filled vinyl grips; resistant to heat, oil and most solvents.

Spare Striking Faces For Thor Hammers

For malleable iron head hammers and split head hammers.

Copper Face

Senator® Engineers' Ball Pein Hammer

Manufactured from finest quality drop forged steel, hardened and tempered with ground & polished heads.

Hickory Shaft

Thorex Nylon Faced Hammers

Chrome plated zinc heads with two screw on nylon striking faces.

Plastic Handle

Thorace Dead Blow Hammers

Hollow die cast head partially filled with steel shot, which adds to the weight of the impact and prevents rebound, delivering a dead blow. The handle is manufactured from aluminium alloy with a shock absorbent non slip rubber grip. Supplied with two screw in replaceable white nylon faces.