Indexa-Seiki Tapping Collets

Slipping clutch type. To suit Indexa-Seiki tension and compression type tapping chucks.

For all technical specifications please refer to our catalogue.

DIN SZ2

Granlund Size 1 Insert Drills

Type LB HSS Tol. h8 flute 40mm.

When combining insert drills with countersinks, the drill must break through the work piece before secondary cutting commences and must not be used for blind holes.

For all technical specifications please refer to our catalogue.

Allied Maxcut Series 0 and 0.5 Holders

Diameter range: 12.98 to 17.65mm.

For all dimensional specifications please refer to our catalogue.

Taper Shank

TPKN

QP25 (ISO P25) Uncoated. For medium and finish milling of Steels.

2204

To suit: Indexa Seiki "Tri-square" Milling Cutter.

Granlund HSS Size 1 Counterbores

Type W. HSS. Tolerence P8.

Counterbores W with a diameter of 50mm and larger are all made with a driving lip. These sizes should be used in the appropriate type M toolholder.

For further specifications please refer to our catalogue.

XP-90C Weldon End Mills

Positive 90 approach milling cutter, using size 10/16 inserts allowing depth passes and high feed per teeth. Torx screw allows for good chip ecacuation. Plasma Ion coating offers longer tool life and greater hardness that is more resistant to wear. Through coolant as standard.

XP-90C End Mills For AP_T 16 Inserts

Indexa-Seiki R8 Shank Morse Adaptors

R8 shank morse adaptors

Morse Taper Adaptor

PSC and PSCa (adjustable) Collets for Plain Shank Cutters

Tru-Loc Collets are available for plain shank cutters in two different styles, PSC non adjustable and PSCa - Collets with an adjustable back-stop screw to allow more accurate & consistent cutter replacement.

For all dimensional specifications please refer to our catalogue.

PSC(a) Type

Indexa-Seiki FM - Face Mill Adaptors

From an extensive programme of quality spindle nose tooling, used with an extensive range of face and shell mills

Indexa-Seiki VDI Toolholders

Manufactured to DIN 69880. Suitable for use in NC lathes with VDI fixing disc. Features: All tools are fully carburised and hardened. Surface hardness of 58 - 60HRC. Tensile strength above 1000N/mm2. Surfaces blued; seat, parallel shank and shoulder ground. Tools can be adjusted in-situ on radial and axial toolholders. Seat shim allows two tool sizes to be used with one toolholder. Ball regulator (bullseye) provides easy coolant control.

E2-1 Boring Bar Sleeves