Indexa-Seiki VDI Toolholders

Manufactured to DIN 69880. Suitable for use in NC lathes with VDI fixing disc. Features: All tools are fully carburized and hardened. Surface hardness of 58-60HRc. Tensile strength above 1000N/mm2. Surfaces blued; seat, parallel shank and shoulder ground. Tools can be adjusted in-situ on radial and axial toolholders. Seat shim allows two tool sizes to be used with one toolholder. Ball regulator (bullseye) provides easy coolant control.

Radial

Short B2 Left Hand

Indexa-Seiki MT-Morse Taper Adaptors

With internal morse taper socket. For use on drilling machines etc. For drills, core drills, reamers etc. Manufactured to stringent quality standards.



To DIN69871/A

Indexa-Seiki MT-Morse Taper Adaptors

With internal morse taper socket. For use on drilling machines etc. For drills, core drills, reamers etc. Manufactured to stringent quality standards.



To DIN69871/A

PSC and PSCa (adjustable) Collets for Plain Shank Cutters

Tru-Loc Collets are available for plain shank cutters in two different styles, PSC non adjustable and PSCa - Collets with an adjustable back-stop screw to allow more accurate & consistent cutter replacement.

For all dimensional specifications please refer to our catalogue.

PSC(a) Type

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 3.0-26.
(D)41mm x (L)46mm.

ER40

Indexa-Seiki Tapping Chucks - Tension & Compression Type

With axial compensation. Suitable for use on boring machines and machining centres. To ISO/DIN 69871-A Taper Shank.

For all technical specifications please refer to our catalogue.

ISO/DIN 69871-A Taper Shank

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 1.0 - 7.0.
(D)11.5mm x (L)18.0mm.

ER11

Indexa-Seiki VDI Toolholders

Manufactured to DIN 69880. Suitable for use in NC lathes with VDI fixing disc. Features: All tools are fully carburised and hardened. Surface hardness of 58 - 60HRC. Tensile strength above 1000N/mm2. Surfaces blued; seat, parallel shank and shoulder ground. Tools can be adjusted in-situ on radial and axial toolholders. Seat shim allows two tool sizes to be used with one toolholder. Ball regulator (bullseye) provides easy coolant control.

ER Collet Chucks

E4 to DIN 6499/B

Indexa-Seiki Tapping Chucks - Rigid Type (No Compression)

With through coolant. Suitable for use on CNC machines set up for rigid tapping.

For all dimensional specifications please refer to our catalogue.

MAS 403 BT Taper Shank

Indexa-Seiki? "Tri Square" Milling Cutters

Uses top clamping triangular inserts to produce a 90 shoulder at the edge of a milled face. This is of major benefit when taking a number of cuts across a face as the shoulder produced is without steps.