ISCAR?s new Single-Ended Insert for Parting With an Improved Clamping Method

TAG Insert Features
* Very rigid clamping in a tangentially oriented pocket.
* Enables machining at very high feed rates and provides excellent straightness and surface finish.
* Recommended for parting large diameter parts and for * Offers a free, unobstructed chip flow, since there is no upper jaw as in the other clamping systems (very important in deep grooving and parting applications.
* The combination of tangential clamping and free chip flow results in improved tool and insert life time.
* Provides a solution to the problem of inserts being pulled out during retraction.

The TAG inserts are available with the familiar J- and C-Type chipformers, with neutral and angular frontal cutting edges. The new tools are equipped with a user-friendly clamping and extraction device. The TANG-GRIP family includes square shank tools, blades and inserts in 1.4 - 9.5mm widths in the most advanced IC830 and IC808 SUMO TEC grades. The blades are in standard siuzes which fit ISCAR's standard blocks.

Tang-Grip? TAG N-J Parting & Grooving Inserts

First choice for soft materials, parting of tubes, small diameters and thin-walled parts. Cutting edge with positive rake. General applications on low carbon steel, alloy steel, austinitic stainless steel. Low-to-medium feed.

IC808 Grade Description:
(P15-P30/M20-M30/K20-K40/ S15-S25/N15-N25/H20-H30) SUMO TEC TiAlN PVD coated. A tough submicron substrate. For machining heat resistant alloys, austenitic stainless steel, hard alloys and carbon steel at medium to high cutting speeds. Excellent notch wear and built-up edge resistance.

DCMT

QX5030 (ISO P25-P35 M15-M25) An excellent general purpose grade for medium roughing and finishing on steel and stainless steel.

CNMG

Suitable for External/Internal Toolholders

VCGT

K10 (ISO K10) Uncoated. Used in combination with a high rake geometry for machining Aluminiums, Plastics and other soft Non-Ferrous materials.

Sandvik Threading Toolholders and Inserts

Sandvik's 266 CoroThread toolholders and inserts provide a high level of stability for threading applications in demanding industries, where precision is paramount.

266 CoroThread UN External Right Hand Threading Insert

Grade description for GC1125:
New PVD-TiAIN-based coating and substrate combine to improve wear resistance and security for threading, providing the option of running at higher cutting speeds or for a longer time in cut.

CCGX

Suitable for External/Internal Toolholders

CNMG

QX5030 (ISO P25-P35 M15-M25) An excellent general purpose grade for medium roughing and finishing on steel and stainless steel.

Iscar HELITURN Toolholders

Important:
These tools were designed to be used
only with the HELITURN LD inserts.

Iscar PWLNR /L -X HELITURN Lever Lock Toolholders

DCMT

Suitable for External/Internal Toolholders

Sandvik Threading Toolholders and Inserts

Sandvik's 266 CoroThread toolholders and inserts provide a high level of stability for threading applications in demanding industries, where precision is paramount.

266 CoroThread UN External Right Hand Threading Insert

Grade description for GC1125:
New PVD-TiAIN-based coating and substrate combine to improve wear resistance and security for threading, providing the option of running at higher cutting speeds or for a longer time in cut.