Indexa-Seiki Indexable Tooling Spares

Indexa - Carmex toolholder pockets are manufactured with a 1.5 positive Helix angle as standard. Other anvils are available to change the helix angle of the insert as required by the diameter and pitch of the thread.

Indexa-Seiki? Threading Toolholders

An "On Edge" three cornered vertical threading system for use in circumstances where other threading systems would foul the component or lathe centre. Toolholders have a helix angle incorporated into the pocket which satisfies the majority of applications. The relationship between diameter and pitch is shown at the foot of the page and illustrates the parameters within which this threading system will be applicable.

Vertical Threading

Indexa-Seiki? Threading Toolholders

Dual DER/L - External

External

Indexa-Seiki? Threading Toolholders

SIR/L - Internal

Screw-on

Indexa-Seiki? Threading Toolholders

Dual DER/L - External

External

Indexa-Seiki Indexable Tooling Spares

To suit threading toolholders

Indexa-Seiki? Threading Toolholders

An "On Edge" three cornered vertical threading system for use in circumstances where other threading systems would foul the component or lathe centre. Toolholders have a helix angle incorporated into the pocket which satisfies the majority of applications. The relationship between diameter and pitch is shown at the foot of the page and illustrates the parameters within which this threading system will be applicable.

Vertical Threading

Indexa-Seiki? Threading Toolholders

Dual DER/L - External

External

Indexa-Seiki Indexable Tooling Spares

To suit threading toolholders

Indexa-Seiki? Threading Toolholders

SIR/L - Internal

Screw-on