Sliding Bevels

Sliding bevels are used for marking angle lengths; 250 & 300mm. All measuring tools are made from aluminium block and with a steel blade. The scales are etched on the surface which ensures long durability. Edge holder for accurate positioning.

Hardpoint Fine Hand Saw

High quality steel blade with razor sharp double-ground, hardpoint teeth that cut in both the push and pull stroke. Water based lacquer gives four times better rust protection on blade than traditional lacquers. Ergonomically designed soft-grip handle.
Blade size: 550mm (22??).
Teeth per inch (TPI): 9.

Irwin Marples Bevel Edge Wood Chisel Sets

Hardened and tempered one piece steel blades, used for chamfering, dovetailing and making clean cuts in tight corners. With 'splitproof' handles which are designed to absorb hammer blows and hard demanding woodwork. Available in a set of 4 or 6 chisels.

M373 Set of 6 Chisels

Contents: 6, 10, 13, 19, 25 and 32mm.

Cabinet Scrapers

Used for removing fine shavings from wood surfaces, leaving a very smooth finish. Manufactured from hardened, tempered and polished carbon steel. Available in 2 sizes: 5" x 2.5" and 6" x 3".

Irwin Marples Mortice Marking Gauge M2154

Manufactured from rosewood, with a brass thumbscrew, adjusting slide for fine adjustment and brass facing strips on the front of the stock, which are wear resistant and improve accuracy. Fitted with a single and a double spur for marking out mortices.

Cabinet Scrapers

Used for removing fine shavings from wood surfaces, leaving a very smooth finish. Manufactured from hardened, tempered and polished carbon steel. Available in 2 sizes: 5" x 2.5" and 6" x 3".

Irwin Marples Corner Clamps

Heavy-duty accurate mitre clamp. Solid grey cast iron body with precision machined clamping surfaces. The open design gives easy access for gluing and nailing. Pre-drilled holes enable the clamp to be fixed to a block of wood for securing between the jaws of a bench vice. Available in 2 capacities: 50mm (2") and 110mm (4,1/4").

Irwin Marples Corner Clamps

Heavy-duty accurate mitre clamp. Solid grey cast iron body with precision machined clamping surfaces. The open design gives easy access for gluing and nailing. Pre-drilled holes enable the clamp to be fixed to a block of wood for securing between the jaws of a bench vice. Available in 2 capacities: 50mm (2") and 110mm (4,1/4").

Irwin Marples Marking Gauge M2049

Standard timber marking gauge, manufactured from plantation grown rosewood, and featuring hardened steel spurs for durability and scribing accuracy.

Shaver Tool

With tough enamelled alloy bodies and high carbon heat treated steel blades.



With plastic holder.
Blade length: 63mm.
Blade width: 40mm.
Overall length: 185mm.