Rexnord Roller Chain

With RexPro, Rexnord set a new standard for quality chains. The RexPro chain is the result of further developing the
Rexnord high performance chain. Over a timespan of four years the combination of selected steels, optimised manufacturing and the RexPro lubrication have all achieved these outstanding product characteristics.

RexPro Simplex Roller Chain British Standard

Simplex Chain

Conti Synchrobelt Timing Belts

? Moderately oil-resistant
? Temperature range -20C up to +100C
(depending on application)
? Non-aging and ozone-resistant
? Suitable for tropical climates
Size designation (example)
150XL037
150 150? (381.0mm) pitch length
XL 0.2? (5.08mm) tooth pitch
037 3/8? (9.25mm) timing belt width

DIN 5296

Wide Series Deep Groove Ball Bearings - C3 Clearance

Slightly wider than the 6200 series with the same bore and outside diameter. Designed to withstand radial loads, withstand axial loads in both directions and operate at high speeds of rotation.

DIWA - Submersible Pumps

Submersible pumps for dirty water, drainage and sewage.
Body made from AISI 304 stainless steel.

Power supply: 230V/50Hz/1Ph.
Temperature of pumped liquid: to 50C.
Maximum immersion depth: 7m.
Free passage: up to 8mm.
10mtr. power cable.
*Type SG are supplied without float switch for manual operation.

Applications
Residential-waste water.
Light Industry-waste water.
(DIWA GT version with fixed vertical float switch system and
three-phase models are also available.)

DIWA

SNR Deep Groove Ball Bearings

Rubber seals inserted into the outer raceway and in contact with the inner race providing protection against the ingress of moisture, dust and other foreign objects.

Single Row Deep Groove Ball Bearings - C3 Internal Clearance

C3 Bearings have an internal clearance to cope with high speed environments where excess heat is generated.

Open Type

Without seals to allow for the free circulation of either oil or grease, used in gearboxes and other assemblies where a lubricant is already present.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Bolt Flanged Unit - SF Type - Four Bolt

Cast iron self lube units with bolt holes.

Deep Groove Ball Bearings - C3 Clearance

C3 bearings have an additional internal radial clearance to cope with high speed environments where excess heat is generated.

Shielded type:

With metal shields inserted into the outer raceway, these fit in closely to the inner race providing moderate protection against mechanical damage, and against the ingress of moisture, dust and other foreign objects. The shields also retain the pre-filled grease in the bearing. Shields can be easily removed for applications that only require one shield.

SK High Power Wedge Belts

To ISO 4184, BS 3790, DIN 7753 and
USA Standard RMA/MPTA.
The wrapped Optibelt SK wedge belt has been developed with mechanical engineering in mind.
It transmits substantially more power than the classical V-belt with comparable top width.
The Optibelt SK high performance wedge belt is preferred for use in heavy mechanical engineering with very high load requirements, which can be over 2000kW.
*Belts marked are part of the S = C PLUS range with an efficiency of approximately 97% and are suitable for use and require no service or adjustment during service life.

Belt Section 13/A (SPA/13)