V-Grooved Pulleys for Taper Bushes

Grooves to ISO/BS/DIN 2211.

Belt Section 10/Z (SPZ/10)

Single Row Deep Groove Ball Bearings - C3 Internal Clearance

C3 Bearings have an internal clearance to cope with high speed environments where excess heat is generated.

Shielded Type

With metal shields inserted into the outer raceway, these fit in closely to the inner race providing moderate protection against mechanical damage, and against the ingress of moisture, dust and other foreign objects. The shields also retain the pre-filled grease in the bearing. Shields can be easily removed for applications that only require one shield.

Taper Bore Bushes

Used to fit flywheels, pulleys and chain sprockets onto an electric motor shaft.
Taper Bore Bushes are easily assembled and are an ideal method of mating to a shaft without the need for machining.
To lock the shaft tighten up two grub screws,
to unlock it you remove the screws, inserting one in the third hole and wind in to lever off the hub from the shaft.
Material: EN-GJL 200/DIN EN 1561.

Metric Sizes

Keyways to DIN 6885 Part 1.
* Bores marked have shallow keyways.

Tab Washers

Tab washers are used for securing KM series lock nuts. They have an inner tab for location on the adaptor sleeve. One of the external tabs is bent over a slot when used wit the
KM series lock nuts.

Housed Bearing Units

Housed Bearing Units are one of the most effective and easiest solution to accomodate misalignment. Units below consist of housing and insert. A wide range is available including Imperial sizes. Please ask for further information.

Take-Up Units - ST Type

Cast iron self lube units are used where shaft adjustments are required on applications such as conveyor systems.

Rexnord Roller Chain

With RexPro, Rexnord set a new standard for quality chains. The RexPro chain is the result of further developing the
Rexnord high performance chain. Over a timespan of four years the combination of selected steels, optimised manufacturing and the RexPro lubrication have all achieved these outstanding product characteristics.

RexPro Simplex Roller Chain British Standard

Simplex Chain

Angular Contact Ball Bearings

Single row angular contact bearings have the raceways arranged that the forces are transmitted from one raceway to the other at a specific contact angle and can only support axial forces in one direction. They must be axially adjusted against a second bearing fitted in a mirror image.

Table Top Slat Chain

A complete range of table top chains and sprockets in steel, stainless steel and molded thermoplastics. These are manufactured specifically for a conveying applications.
Some table top chains have been standardised between manufacturers. We show below the most popular ranges but with many specialty attachments and options available on table top chain, please contact your local service centre to assist in identifying and recommending the right table top chain for your application.

915 Series - Straight Running

Reduced trasversal and longitudinal gap for better product handling.
Material: Superior grade of cold rolled special ferritic stainlesssteel.
Length: 10?.

Optibelt Timing Belts

Optibelt?s High Power Omega HP timing belts
employ rubber reinforced with aramid fibres
to give exceptionally strong and
dimensionally stable teeth.
Up to 3x the power of conventional belts.
Very high power.
Low maintenance - extremely low stretch.
No length matching required.

Omega HP High Power Timing Belts

Deep Groove Ball Bearings - C3 Clearance

C3 bearings have an additional internal radial clearance to cope with high speed environments where excess heat is generated.

Rubber sealed type:

With rubber seals inserted into the outer raceway and in contact with the inner race providing protection against the ingress of moisture, dust and other foreign objects. The seals also retain the pre-filled grease in the bearing. Seals can be easily removed for applications that only require one seal.