Oxford Precision™ Dial Indicating Bore Gauges

Suitable for rapid, accurate measurement of size, concentricity, wear, taper, etc., in a wide range of bores. For workshop and inspection use. All models have one fixed and one moving anvil and a self-adjusting centre shoe. A datum point' can be set by using a setting ring of a known diameter or a micrometer. Zero' the gauge to this datum point by rotating the bezel to align zero' with the indicator. To check a bore is within tolerance, the limit hands can be fixed as required. All anvils are spring loaded to expand into the bore. For accurate reading ensure the stem of the gauge is parallel to the axis of the bore. This can be checked by 'rocking' the gauge back and forth until the smallest diameter is found. All models have interchangeable anvils to cover a range of bore sizes.

2/3 Point Bore Micrometers - Analogue

Economical range of mechanical three point micrometers with XT (extended travel) feature on all models between 6 - 200mm capacity. This allows a wide measurement range without the need to change anvils. Both the measuring head and setting ring are UKAS calibrated (6-200mm range only).

Oxford 3 Point Bore Micrometers

Designed to self-centre, for accurate measuring of bores.
Extension rods for measuring 170mm deep on 11 - 20mm and 220mm deep on 20 - 40mm.
Satin finish, fitted with knurled ratchet stop.