Oil Filter Plier

Manufactured from hardened and tempered chrome vanadium with chemically blackened corrosion resistant finish and vinyl grip. Three position rapid jaw adjustment with high grip tooth profile, ensures the minimum amount of effort is required to remove or fit oil filters.

LED Battery & Alternator Tester 12V

Indicates condition of battery and the output of an alternator.
For automotive use on 12V DC systems only.
Magnetic back.
0.8m long cable leads.

Hydraulic Hose Clamp

Spring loaded, clamps brake and fuel hoses to allow brake/clutch slave cylinders to be disconnected or removed with the minimum of fluid loss.

Kennedy Fuel Container

Suitable for transporting and storage of Petroleum Spirit and Diesel. UN approved, conform with S.I. 1982/630 Petroleum Spirit Plastic Container Regulations 1982.

5 Litre Fuel Container

Green for unleaded/lead free fuel.

Standard 6 to 12V Circuit Tester

Suitable for use with power on. For 6 & 12V automotive systems only. Locates shorts, earth & open circuits Probe length 45mm. 1m lead Super sharp tempered steel probe to test through wire insulation.



Super sharp tempered steel probe circuit tester to test through wire insulation when power is switched on. Tests 6 & 12V automotive systems only, locates earth, short and open circuits. Tester is fitted with a 1m lead for convenience, 45mm probe and a strong transparent plastic handle.

7 Piece Panel Beating Set

A comprehensive panel beating set containing: 1 x 12oz shrinking hammer.1 x 12oz flat faced bumping hammer. 1 x 10oz round finishing pick.1 each: curved 1.2kg, utility 1.2kg, heel and toe dolly.The hammerheads are manufactured from forged high carbon steel and then ground and polished on the faces and cheeks to a mirror finish. The hammer shafts are manufactured from solid hickory, with an octagonal cross section for improved grip and control when in use. The dollies are manufactured from drop forged medium carbon steel (SAE/AISI 1055) then heat treated and polished to a high mirror finish. Each one is laser etched for easy identification.Supplied in an impact resistant case that prevents the hammers and dollies clashing together and damaging the high polish finish, whilst in transit.

What "Practical Classics" magazine say..."Best Buy"

"Full house to this excellent value set. The four dollies are beautifully finished and profiled, and are a good usable weight. The hammers are also superb, combining decent weight, well shaped shafts and good length. The faces are big enough for effective planishing too. Final plus point is the moulded case, which prevents the contents bashing together."

Cylinder Hone Stone Sets

Contain 3 x 100mm stones and 3 replacement cotter pins.

To suit 028100

Kennedy Ratcheting Axle Stands

Suitable for supporting raised vehicles or equipment. Wide angled base, stamped and welded steel frame with solid steel control lever & protective red enamel coating. 10-position ratchet design that automatically locks when raised. Sold as pairs.

6 Tonnes Ratcheting Axle Stands (Pair)

6 Tonnes safe working load per stand (12 tonnes per pair).

Baty Digital Tread Depth Gauge

Suitable for tread depth, brake shoe and pad wear measurement.
Large LCD display
Zero setting at any position
Metric/Inch system interchange
Manual power On/Off



Specification
Range; 0-25mm
Resolution; 0.1mm
Power; 1.5V
Working Temperature; 0-40 deg C

Plastic Creeper Board

Durable, lightweight moulded plastic creeper board ideal for use in garages. Padded headrest with 4 x 50mm polypropylene caster wheels. Capacity: 127kg (280lbs). Dimensions: 910(L) x 405(W) x 105(H)mm. Weight: 3kg.