Cylinder Hone

Suitable for use with electric or air power drills. To hone and deglaze cylinder bores. The flexible drive shaft allows for easy alignment within the cylinder. Supplied complete with 220 grit stones.

Sykes-Pickavant Medium Duty Ball Joint Separators

Manufactured from hardened steel with tough durable epoxy coating. The lever can be set to one of it's four positions simply by releasing the pivoting pin. The tapered slim fork allows easy access. Suitable for use on most car and light commercial ball joints. Throat depth: 080500 - 30mm. 080700 - 36mm.

Sykes-Pickavant Adjustable Oil Filter Remover

Manufactured from hardened steel. The geared jaws automatically tighten as the load increases to securely grip the filter for safe removal. For use with a 3/8" square drive ratchet wrench or 19mm open ended spanner.

Three Jaw Oil Filter Wrench

Hydraulic Hose Clamp

Spring loaded, clamps brake and fuel hoses to allow brake/clutch slave cylinders to be disconnected or removed with the minimum of fluid loss.

Oil Filter Remover

Die cast screw with non stretch steel band. The tool is looped over the filter and tightened, once the filter is gripped firmly it can be removed. Suitable for one handed use in areas of confined access.

Steel Loop Oil Filter Removers

Sykes-Pickavant Ball Joint Separator

080600 Strengthened steel body and forks. The longer length allows greater force to be applied to separate the ball joint, can be used from outside the wing. Throat depth: 88mm. Overall length: 420mm.

Anti-Freeze Tester

For checking the percentage of ethylene glycol-based coolants in an engine cooling system. Shows lowest temperature in C to which the cooling system is protected.

Cylinder Hone Stone Sets

Contain 3 x 100mm stones and 3 replacement cotter pins.

To suit 028100