Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

"Multipull" Blind Housing Puller

For the removal of blind housing bearings without the need to dismantle machinery or remove the running shaft. Positive seating allows even tension on the inner and outer bearing rings reducing resistance. The stabilisers reduce sideways movement and self centres the puller. The three sets cover a range of ISO bearings, if there is no ISO reference on the bearing refer to the puller spread and adaptor.



098000 - ISO designation: 6004-6010, 6004-6015. Reach: 125mm. Adaptor diameter: 5.5 - 8mm.098100\t - ISO designation: \t6299-6205, \t6200-6211 & 6212-6222. Reach: 415mm. Adaptor diameter: 5.5 - 12.5mm.098200\t - ISO designation: \t6300-6302 Reach: 490mm. Adaptor diameter: 16 - 31.75mm.

Thin/2 Jaw Mechanical Pullers

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
086000 Spread: 75mm. Reach: 75mm.
086100 Spread: 150mm. Reach: 150mm.
086200 Spread: 150mm. Reach: 225mm.
086300 Spread: 150mm. Reach: 225mm.

Hydraulic Pullers

Ram Extension Bars

Hydraulic Pullers

Ram Extension Bars

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Hydraulic Pullers

Have a simple, grease filled ram instead of the mechanical force screw. This produces more power easily & efficiently. The spring loaded plunger provides direct, non- twisting application of thrust safely.

2 and 3 Jaw Kit

Combination twin/triple leg puller kits. Complete with ram extension. 155000: Spread: 150mm. Reach: 150mm. Extension: 50mm. Contains components to make up 4 different pullers. In metal box.

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Hydraulic Pullers

Have a simple, grease filled ram instead of the mechanical force screw. This produces more power easily & efficiently. The spring loaded plunger provides direct, non- twisting application of thrust safely.

Thin Jaw Hydraulic Pullers - Combination Set Kit

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
186504 Spread: 225mm. Reach: 225mm. Extension: 50/150mm. Contains components to make up to five different hydraulic and one mechanical thin jaw puller.In metal box.

Thin/2 Jaw Mechanical Pullers

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
086000 Spread: 75mm. Reach: 75mm.
086100 Spread: 150mm. Reach: 150mm.
086200 Spread: 150mm. Reach: 225mm.
086300 Spread: 150mm. Reach: 225mm.