Self Tapping Screws

Self-tapping steel screws. AB zinc-plated. For use on sheet metal and other malleable materials. DIN: 7982 C Z.

PoziDriv - Countersunk (Inch)

Socket Set Screws

High tensile alloy steel. Grade 14.9. DIN 916.

Metric - Plain Cup Point - A2 Stainless Steel

For use against hardened shafts. Ideal for use in ductile castings such as zinc, aluminium etc. where high tightening torques are not practical.

High Tensile Hexagon Head Bolts

BSW Thread. BS1083. Grade R. Self colour.

Inch (BSW) - Self Colour

Socket Head Countersunk Screws

High Grade Alloy Steel to BS EN ISO 898/1 Grade 10.9. Suitable for all high tensile applications. Maximum operating temperature (unplated): 300C. For applications that require a flush finished surface. Precisely controlled countersink angle allows maximum flushness and sidewall contact. Dimensions to DIN 7991.

Metric Sizes - Standard Self Colour

Kennedy Extractable Dowels

Extractable dowel pins complete with inner thread and slight flats for air release. DIN 7979D. EN 28735. ISO 8735. Material: AISI-52100 or DIN 1-3505 100 Cr 6. Hardness: 57-63 HRC.

Socket Head Countersunk Screws

High Grade Alloy Steel to BS EN ISO 898/1 Grade 10.9. Suitable for all high tensile applications. Maximum operating temperature (unplated): 300C. For applications that require a flush finished surface. Precisely controlled countersink angle allows maximum flushness and sidewall contact. Dimensions to DIN7991.

Metric Sizes - Bright Zinc Plated

Hexagon Full Nuts

Self colour. Conform to DIN 934.

Inch (BSW)

Socket Head Cap Screws

High Grade Alloy Steel to BS EN ISO 898/1 Grade 12.9. Suitable for all high tensile applications. Maximum operating temperature (unplated): 300°C. Dimensions to BS EN ISO 4762 DIN 912.

Metric Sizes - Self Colour

Silver-TT? Twin Thread Woodscrews

Ideal for power driving into hard wood, soft wood, MDF and chip-board. High helix double thread, ?drives home? in half the time of standard screws. Precision manufactured, thinner shank reduces wood splitting. Fully heat-treated and extremely hard for high resistance to breakage in high torque applications. Plated to five microns for greater corrosion-resistance. 35 point angle usually needs no pilot hole.

Kennedy Thread Repair

Kennedy Professional Thread Repair Wire Inserts are the easiest and quickest inserts to install to repair damaged or worn threads, you simply screw the insert into the pre-drilled and tapped hole, until the drive tang breaks off. They can be used with plastics or other materials provided that the material is strong enough to withstand the expansion of the insert as the screw thread locks into the wall of the hole. They are also suitable for new applications where, because of their mechanical strength benefits their introduction may result in the use of thinner sections or lighter parent materials without sacrificing thread strength they can also be used for converting from metric to inch and vice versa.

Most inserts are 1.5x diameter for length. For example:- M6 is 9mm long.
Other lengths are available on request.

Available in Metric, UNC, UNF, BSF, BSP and BSW sizes.

For all dimensional specifications please refer to our catalogue.

Wire Thread Insert Kits (UNC)

Each Kennedy Professional Thread Repair Wire Insert Kit is supplied complete with a Hand Tap, Inserting Tool and Inserts.