Indexa-Seiki Arbor Solid Spacers

Hardened and ground parallel and perpendicular to an accuracy of 0.0002" to ensure accurate running cutters, when used on milling machine arbors. With standard keyways.

Indexa-Seiki? ER Collets

Indexa-Seiki? ER collets are the most versatile toolholding system for any operation that utilises a round shank cutting tool in a machining centre. Typical applications include drilling, milling, tapping, reaming and boring.

When Indexa-Seiki? ER collets are used with round shank cutting tools the collet chucks centralise the cutting tool and if all the ER system components have been maintained correctly, this should result in increased tool life, higher feed rates, better work piece accuracy and enhanced work piece finish.

ER Collet Set

Indexa-Seiki? ER Collets are available in the in a range of sizes to maximise efficiency in most applications, they are manufactured from hardened and tempered high alloy steel. All supplied in hardwearing bench cases with protective foam inserts.

Conform to DIN 6499.
Up to 10.0mm - 0.015mm TIR.
11.0 to 18.0mm ? 0.015 to 0.020mm TIR.
19.0 to 26.0mm ? 0.015 to 0.020mm TIR.

For all technical and dimensional specifications please refer to our catalogue.

Indexa-Seiki VDI Toolholders

Manufactured to DIN 69880. Suitable for use in NC lathes with VDI fixing disc. Features: All tools are fully carburised and hardened. Surface hardness of 58 - 60HRC. Tensile strength above 1000N/mm2. Surfaces blued; seat, parallel shank and shoulder ground. Tools can be adjusted in-situ on radial and axial toolholders. Seat shim allows two tool sizes to be used with one toolholder. Ball regulator (bullseye) provides easy coolant control.

ER Collet Chucks

E4 to DIN 6499/B

Indexa-Seiki SL - Sidelock Adaptors

For Weldon shank cutters, adaptors and tapping chucks. Manufactured to stringent quality standards.

Standard Length

To BT-MAS 403

Indexa-Seiki FM - Face Mill Adaptors

From an extensive programme of quality spindle nose tooling, used with an extensive range of face and shell mills

PSC and PSCa (adjustable) Collets for Plain Shank Cutters

Tru-Loc Collets are available for plain shank cutters in two different styles, PSC non adjustable and PSCa - Collets with an adjustable back-stop screw to allow more accurate & consistent cutter replacement.

For all dimensional specifications please refer to our catalogue.

PSC Type

Indexa-Seiki? "Tri Square" Milling Cutters

Uses top clamping triangular inserts to produce a 90 shoulder at the edge of a milled face. This is of major benefit when taking a number of cuts across a face as the shoulder produced is without steps.

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 2.0-20.
(D)33mm x (L)40mm.

ER32

Indexa-Seiki Tapping Collets

Slipping clutch type. To suit Indexa-Seiki tension and compression type tapping chucks.

For all technical specifications please refer to our catalogue.

ISO529 SZ1

Indexa-Seiki Tapping Chucks - Tension & Compression Type

With axial compensation. Suitable for use on boring machines and machining centres. To MAS 403 BT Taper Shank.

For all technical specifications please refer to our catalogue.

MAS 403 BT Taper Shank