Floor Patch

Bonds to new or old concrete producing a walkable surface in eight hours. Resistant to chemicals and heat up to 120C.

Loctite Hysol 3473 A&B - Metal Set S3 - Fast Cure

Loctite Hysol 3473 A&B is a steel filled, 2K-Epoxy adhesive, for emergency repairing and rebuilding worn metal parts. Ideal for repairing pipes and castings as well as cracks in housings and machine parts.

Typical Properties
? Mix ratio by volume: 1:1
? Mix ratio by wight: 100:100
? Working life: 6 min.
? Fixture time: 15 min.
? Colour: Grey
? Viscosity: Putty
? Shear strength (GBMS): 20 N/mm
? Compressive strength: 60 N/mm
? Operating temperature: up to 120C

Loctite Hysol 3475 A&B - Metal Set A1 - Slow Cure

Loctite Hysol 3475 A&B is an aluminium filled, 2K-Epoxy adhesive, for repairing and rebuidling worn metal parts. Ideal for repairing castings and cracks in housings and machine parts.

Typical Properties
? Mix ratio by volume: 1:1
? Mix ratio by wight: 100:100
? Working life: 45 min.
? Fixture time: 180 min.
? Colour: Grey
? Viscosity: Putty
? Shear strength (GBMS): 20 N/mm
? Compressive strength: 70 N/mm
? Operating temperature: up to 120C

Plastic Steel Putty (A)

Steel filler. Bonds to metals, concrete, and some plastics. Resistant to rust, oil, petrol, water and chemicals. Machinable. Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Devcon 50ml Devweld 530

Rapid curing multi-purpose toughened structural methacrylate adhesive which produces superior load bearing bonds to engineered plastics, metals, ceramics and many other difficult substrates. Minimal surface preparation. Resistant to weathering, humidity and wide variations in temperature.

Magic Bond

A two colour stick which seals leaks and repairs gouges in steel, aluminium, wood, fibreglass, concrete and ceramics. Works on wet surfaces, can be painted, sanded, machined, tapped or drilled and is ready for use in 1 hour.
Max Operating Temperature: 121C.
Pot life: 10 mins

Epoxy Repair Mortar

Multi-use epoxy resin to repair damaged concrete floors, steps and ramps. fast setting (3 - 6 hours) to a granite hard finish. For use where fillers or normal mortars would fail. Ideal for thin screeds (5mm) on concrete, stone, steps, floors and sills. No priming necessary. Coverage: 1kg covers approximately 0.12m2 at 5mm thick.

Flexane Liquid

Good for abrasion/tear resistant linings. Protects against vibration, shock & wear. Cost-efficient moulds (self-levelling).



Flexane 94: Shore 94, relatively rigid. Max Operating Temperature: 82C. Pot Life: 10 minutes. Mix Ratio: 2.19:1.

Epoxy Rapid Metal Tubes

• Specially formulated with stainless steel to form a super strong bond.
• Sets in minutes.
• Suitable for use on most metals including copper, steel, aluminium and iron.
• Can be drilled, filed and painted.
• 2x 15ml tubes.

Plastic Steel Putty (A)

Steel filler. Bonds to metals, concrete, and some plastics. Resistant to rust, oil, petrol, water and chemicals. Machinable. Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.