Ambersil Formula 12 Semi-Permanent Non-Silicone Release Agent

Formulated to release a wide variety of synthetic rubbers and many thermoplastics, such as polypropylene and polyethylene. Forms a thin, inert and thermally stable coating, from which multiple releases can be expected. Fast cure time. Moulding can commence 5–10mins after application. Performance can be enhanced by re-coating once a few releases have been made. Very low mould build up. No film transfer to moulded parts. Operational to 250°C.

Ambersil Non Silicone Mould Release Agent

The non silicone formula will not interfere with post moulding treatments such as bonding,

Seven/2 Heavy duty

Heavy duty film for the release of plastic and rubber mouldings. Operational up to 170C.

Ambersil Silicone Mould Release Agents

Easy and economical to use, enhances surface finishes on mouldings and increases output by reducing rejects. Operational up to 200C.

One/2 Heavy duty

For difficult mouldings.

Ambersil Non Silicone Mould Release Agents for Thermosetting Plastics

Dry film for polyurethane, epoxy resins and polyesters. Will not stain or mark the moulding. Operational up to 180C.

Ten/2

Ambersil Bioweld Weld Anti-Spatter

Water based spatter release agent which gives exceptional results with no harmful solvents, silicones or mineral oils. Odourless, non-flammable and safe in use. Fine spray ensures total control and economical coverage. Prevents spatter adhesion on welding equipment, work pieces, surfaces, jigs and surrounding areas. Film is easily wiped away and leaves no residues. Allows post welding operations, painting, plating, galvanising etc to be undertaken without
interference. Contains a rust inhibiting agent.

Greaseless Lubricant

Multi-purpose lubricant that prevents electrical and electronic failures caused by water penetration, humidity, condensation or rust.
Size: 400ml.

Silicone Release

For integral skin and elastomeric polyurethanes. Silicone release system. Ultra fine spray pattern. Fast evaporating solvent carrier. Imparts a high gloss finish to moulded parts. Does not build up in the mould. Effective to 200°C.

Image not available for 25ltr

Ambersil Silicone Mould Release Agents

Easy and economical to use, enhances surface finishes on mouldings and increases output by reducing rejects. Operational up to 200C.

One/2 Heavy duty

For difficult mouldings.

Ambersil Mould Cleaner 5L

Cleaner for Mould Tools and Dies. Quickly and easily removes oil, grease, old protective films, silicone and non-silicone based release agents. Evaporates to leave a clean, dry surface with no residues. Special formulation permits use on hot production tooling without excessive solvent loss by evaporation.
Size: 5L.

N.B. Picture illustrates 400ml aerosol.

AMS4 Silicone Grease Spray

Multi-purpose silicone grease. XG250 silicone grease in easy to apply form.