SwissTech 4 Flute End Mills Plain Shank Q-Coat Carbide

Centre cutting. Available in HSS-Co 8% Uncoated (for general production machining), HSS-Co 8% TiCN Coated (extends cutter life and improves work material surface finish) and HSS-Co 8% TiALN Coated (dissipates and resists heat, reduces surface friction coupled with high surface hardness).

For all dimensional specifications please refer to our catalogue.

Series 50 4 Flute Short EMC-4PS Carbide

Dimensions to DIN 6535 HA

Indexa-Seiki Indexable Tooling Spares

To suit lever lock external toolholders

Dormer Carbide Stub Drills

R120 - Carbide Stub Drill
For general carbide drilling applications.
120° four-facet point for improved accuracy & hole quality.
Bright Finish. Size Range: 1.0-12.0mm. Manufactured to BS 323, DIN6539.

Sherwood Drill Blanks HSS

Jobber length blank hardened and ground all over. Accurately ground without back taper. Diameter Tolerance: h8. Manufactured to DIN 338.

Series J400

Indexa-Seiki Indexable Tooling Spares

To suit threading toolholders

Indexa-Seiki Indexable Tooling Spares

To suit lever lock external toolholders

3 Flute Straight Shank Countersinks

Sherwood countersinks are a chatter-free cutter that produce an excellent burr-free finish it is capable of deburring and countersinking in one stroke with no "back-off" of tool.
Countersinking a hole leaves an angled conical, chamfered recess on the finished job, for a tapered head bolt or screw to seat correctly into this angled form. Countersink bits can be used for deburring holes as well.
It will also countersink aluminium with no secondary bulge.
Ideal for special applications and exotic materials, a choice of hard coatings is available.

For all dimensional specifications please refer to our catalogue.

100 Degrees

Guhring Machine Chucking Reamers Intermediate Diameter HSS-E

Available in diameters ranging from 2mm to 10mm in increments of 0.01mm. Made from HSS-E steel with a bright finish, left hand spiral flute. For all ferrous and non-ferrous metals and hard and soft plastics. For use on CNC machines, producing high quality reamed holes. Manufactured to DIN 212 and DIN 2172 section 1.

Shank diameter equals cutting diameter - 0.025mm.
dia 2.00 - dia 2.65 / dia 2.66 - dia 10.00 H9.

Diameter Tolerances (to H7)
Up to 5.5mm: plus 0.004mm minus 0.000mm
Above 5.5mm: plus 0.005mm minus 0.000mm.

Code numbers are determined by the nominal diameter. Delete the decimal point; create a four figure number by preceding the figures with a zero, if required. All codes finish with the letter A, i.e. 3.60 becomes 0360A.

For all technical specifications please refer to our catalogue.

EP11 DIN 374 Spiral Point Metric Fine Taps

Steam Tempered Finish
Tolerance: 6H

Indexa-Seiki ER - Single Angle Collets

Collet Dimensions:
Capacity 1.0 - 7.0.
(D)11.5mm x (L)18.0mm.

ER11