Instant Adhesive

For electronic/gauging assemblies where fumes can be a problem and where an unmarked appearance is critical.
Health and Safety friendly.

460 - Low Odour, Low Bloom

278 High Strength Oil Tolerant Threadlocker

Invented by Henkel Loctite as a revolutionary method to lock and seal threaded fasteners, Loctite Threadlockers have found wide acceptance in a range of applications - from delicate electronic components to heavy construction equipment. Loctite Threadlockers are available in varying viscosities and strengths for virtually any application, including exposure to extreme environments.



High strength threadlocker which can be used on as received parts and on applications where operating temperatures can reach 200C. It is also ideal for use on plated bolts including the new zinc/trivalent chrome finishes.

330 - Multi-Bond Structural Adhesives

For use where the gaps between parts are bigger (up to 0.4mm). Resists flex peel and shock loads. Suitable for ceramic, wood, steels, certain plastics and smooth concrete.

Clear Epoxy

Fast cure. Ultra clear. Toughened. Water resistant. Fixture time 12 minutes.

Hysol 3430

222 Screwlock Threadlocker

Low strength, replaces nylon/star/spring washers on screws and threaded fitting where easy dismantling is required, e.g. with a screwdriver. NSF P1 registered.

Loctite 4062 - Instant Adhesive / Ultra Fast Curing

Ideal for highest speed bonding of plastic, metal and rubber. Use with 770 polyolefin primer for difficult to bond plastics. Perfect for bonding material to lampshade frames, bonding small plastic ornaments/symbols to plastic base, rubber strips to clamp faces, rubber end pieces to plastic tubes and high strength locking of plastic fasteners. Replaces 420 and 493. Available in 20g or 50g.

Specifications: operating temperature up to 80°C.
Fixture time (on steel): 3-20sec.
Viscosity mPa.s: 2.
Especially for metal/plastics.

Toughened Epoxy

Good gap fill. High peel strength. Fixture time 4 hours.

Hysol 9461

2701* Studlock Threadlocker

To replace interference studs etc. Also removes the need for blind holes for studs in oil filled castings. Requires light torque for removal. *Replaces 270.

620 - Hi-Temperature Adhesive

A single component anaerobic adhesive which cures between metal surfaces where air is excluded. A secondary heat cure is required to generate the high temperature resistance up to 200C.

Instant Adhesive

Black, toughened adhesive. For small metal parts where the bond must endure heavy peel loads.

480 - Toughened