Hydraulic Puller/Separator Set

10 ton capacity hydraulic ram with tommy bar. Suitable for agricultural machines, garage and industrial use.



Contents: 1 x hydraulic ram. 3 x 4", 6" & 8" puller legs. 1 x twin head. 1 x triple head. 1 x 50mm ram extension. 1 x 100mm ram extension. 2 x 200mm main rods. 2 x 230mm extension rods. 1 x 75 - 105mm separator. 1 x bolt. 1 x ram ring. 1 x ram nut. Blow moulded storage case

Mechanical Puller - 2 & 3 jaw Industrial Kits Reversible/Double Ended/Adjustable

Manufactured from chrome vanadium steel. Each kit contains the components to assemble a 2 or 3 jaw external or internal puller. The legs can be set at 2 different height positions.

Spare Jaw

Spare Jaws to suit Kennedy Mechanical Pullers. Supplied individually.

Mechanical Separator Set

For removing bearings, gears, sprockets & bushes. Metal storage case.

30 - 75mm

Contents: 1 x 7" thrust bolt. 1 x 30-50mm separator. 1 x 50-75mm separator. 2 x 80 & 100mm main rods. 2 x 90 & 110mm. extension rods. 1 x beam.

Spare Jaw

Spare Jaws to suit Kennedy Mechanical Pullers. Supplied individually.

Long Reach Mechanical Puller - 2 Jaw

Used for the removal of gears, ball races, bearings, pulleys and sprockets from a drive shaft. With reach capacities of 75mm, 100mm, 150mm and 200mm. All sizes have double ended, adjustable, reversible legs and can be used for internal and external applications. Selection. Always use a 3 jaw puller whenever possible. This produces better load distribution across the jaws and easier and safer removal of the part. Determine what 'spread' is needed this is the width of the part to be removed. The reach capacity is determined by the depth of the part to be removed.

Industrial Reversible/Double Ended Adjustable

Bearing Separators

For removing bearings, gears and bushes from shafts where access with a mechanical puller is restricted. Separators have tapered edge for insertion behind close fitting bearings, gears and bushes. Jaw hardness 42- 45 HRC.

Hydraulic Separator Set

For removing bearings, gears, sprockets & bushes. 10 ton capacity hydraulic ram with tommy bar. Metal storage case.

HS7 105-150mm & HS11 75-105mm

Both sets contain: 1 x hydraulic ram. 1 x separator. 2 x 200mm main rods. 2 x 230mm extension rods. 1 x beam. 1 x ram nut. HS7 (only) also contains 1x 80mm push plate 1x 50mm ram extension. 1x 100mm ram extension.

6 Way Hydraulic Puller Set

10 ton capacity hydraulic ram with tommy bar. Supplied with 3 position puller legs covering a spread of 50 - 250mm and reach of 0 - 250mm. Can be used as a 2 or 3 legged puller with the same head.



Contents: 1 x combination head. 1 x hydraulic ram. 3 x 3 position puller legs. 6 x leg connectors. 6 x screw nuts, bolts & washers. 1 x 32mm ext. rod. 1 x ram nut. 1 x blow moulded storage case.

Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.