Cutting Nozzles

75mm long acetylene nozzle mix can be used with the majority of popular cutting torches including Saffire 5, 4 & 3, NM250, 400 & 500. Plate thickness refers to mild steel. ASNM: For cutting sheet metal.

Blue insulated liner FOR WIRES
with retainer 0.6/0.9mm

TO SUIT: MB15 MB25 MB36

Binzel Mig Torch Accessories

142.0001 TIP ADAPTOR MB25

Oxygen/Acetylene Welding Hose Sets

Oxy Acetylene Oxygen (blue) and acetylene (red). Kink/ crush resistant. 6 and 8mm (general use). 10mm (heavy duty/flame cutting). Supplied fully fitted complete with hose check
valves.

Small Circle Cutting Attachment

Acts as a centering and stabilising device, clamps directly over the gas tubes of the blowpipe. Allows diameters of up to two times the length of the gas tubes to be cut simply and easily. High quality brass body and screws with chrome plated steel centre pin. Compatible with most blowpipes including 1144, 1143, NMC200, NM250, NM400 etc. Also compatible with cutting attachments.

Saffire Indicator Type Regulators

Gaugeless - with indicator to signal empty cylinder.

Series 1 Single Stage

Murex Process/Heating Nozzles and Adaptors

Fully compatible with most heavy duty welding shanks and blowpipes. For use with blowpipes* 1143, 1144; Saffire NM250; Citogas NMC200. Up to 766,000 Btu/h can be achieved from 5H when used on blowpipe with adaptor. *Use adaptor 120458.

Available in a choice of:
1H (72-163Btu/h [1000s])
2H (102-188Btu/h [1000s])
3H (183-361Btu/h [1000s])
4H (236-401Btu/h [1000s])
5H (281-618Btu/h [1000s])

Propane Heating Nozzles - P-H

Spare Tips for Microset

Replacement tips to suit Microset (CTL-885-5502M).

Murex Mig Accessories

Long, Tapered and Parallel nozzles available.

Nozzles

Murex Lightweight A-FN Cutting Nozzles

A choice of 2 A-FN cutting nozzles, for use with DH lightweight cutting attachments.

144735 Nozzle diameter 1/32". Plate thickness (mild steel) 3-6mm.
144736 Nozzle diameter 3/64". Plate thickness (mild steel) 6-20mm.