Kennedy® Butane Soldering Iron

BS050
Flint type ignition which is built into the cap. Uses standard butane lighter fuel and is simple to refill. Fully adjustable tip temperature control with a safety fuel cut-off when cap is replaced. Textured anti-slip barrel. Supplied with pointed soldering tip. Can be used with double flat, hot air, flame and hot knife, can also be used as a blow torch. Supplied without fuel.

Power rating: 50W.
Soldering temperature: 375°C.
Run time: 60 minutes.
Overall length with cap: 195mm.
Overall length with soldering tip: 180mm.

Senator® Soldering Irons

Senator® soldering irons are suitable for workshop and general electrical repair work. The Thermo-plastic handles are designed for comfort and a firm safe grip.

The mains cable is held by a cable clamping screw which eliminates the strain on the electrical connections. Supplied with a double flat nickel plated tip, 1.2m power lead and 3 amp three pin plug.

Manufactured to BS EN 60335-2-45.

E40 40W Soldering Iron

Soldering Iron Replacement Tips

Double Flat Tip for 75W soldering iron.
Tip size: 6.0mm.

Senator® Soldering Irons

Senator® soldering irons are suitable for workshop and general electrical repair work. The Thermo-plastic handles are designed for comfort and a firm safe grip.

The mains cable is held by a cable clamping screw which eliminates the strain on the electrical connections. Supplied with a double flat nickel plated tip, 1.2m power lead and 3 amp three pin plug.

Manufactured to BS EN 60335-2-45.

E25 25W Soldering Iron

Senator® Butane Soldering Iron Tips

For use with Senator® Butane Soldering Irons.



For use with the Senator needle (SEN-516-2080K) and 2.4mm (SEN-516-2100K) soldering tip.

Butane Soldering Kit

Impact resistant plastic case with shock absorbing high density foam inlay. Contains the Pro 50 butane powered soldering torch. Pointed soldering tip, hot knife tip, blow torch tip and heat blower tip, coil of 60/40 resin cored solder and tip cleaning pad. Supplied without butane.

Fume Hood

Designed for extracting fumes from work area by passing them through a carbon sponge filter. The unit has built in lighting controlled from an individual switch. Lightweight metal construction which clamps to desired work top or table. Fully adjustable both in height and reach. Voltage: 220/230V. Maximum height: 530mm. Maximum reach: 515mm.

600 Series Soldering Stations

Bench or wall mounting. All supplied with stand incorporating sponge & accessory holder.

690-SD

Temperature controlled with a digital C or F readout. 2 lockable memory settings with PIN number security. Supplied with 50W soldering iron.

Replacement Soldering Tips

Iron plated. For Use with PRO 50/PRO 70.

Kennedy® Butane Soldering Iron Tips

Interchangeable tips for use with Kennedy® BS125 soldering iron.