Factory Act Thermometers

Moulded plastic casing with fixture holes. Spirit filled. All factory act thermometers have 16C, 60F clearly marked to comply with health and safety laws.

75/956/0

Range: -10C to 50C, 20F to 120F

Kennedy® Screw Plug Gauges

Made from the finest quality steel and are thoroughly hardened, stabilised and thread ground under strict quality control procedures ensuring a high quality product and optimum wear life.

Single Ended Go

Metric Coarse - Class 6H Tolerance

IP54 Digital Micrometer

Digital micrometer with Absolute/differential functions and water spray protection. 0.001mm/0.00005in scale, mm/in convertible with large lockable display. Supplied in suited plastic case.

Kennedy® Screw Ring Gauges

Made from the finest quality steel and are thoroughly hardened, stabilised and thread ground under strict quality control procedures ensuring a high quality product for optimum wear life.

Go

BSPF - Medium Class Tolerance

Digimate Range of Food Thermometers

Range of 3 thermometers consisting of two pocket thermometers (FM10, FM20) and one hand held thermometer (FM31). The FM10 is a water resistant digital thermometer and the FM20 is a Folding Probe thermometer. The FM31 hand held digital thermometer comes with rubber boot and general-purpose penetration probe included.

FM10 Pocket Digital Thermometer

Specification:
Water Resistant: Yes.
Auto Off: Yes (after 35 minutes).
C/F Selection: Yes.
Data Hold: Yes.
Range: -50C to 150C.
Resolution: 0.1C/F.
Accuracy: plus/minus 1C.
Sampling Time: 1.5 seconds.
Battery: 1.5 Volt button (included).

Adjustable Swivel Angle Surface Plates

With radial locking hardened and ground pins and plain slotted top, are made from close grained cast iron with a Grade 2 ground finish.

Enamel Finish Interchangeable Anvil Micrometers

With one-piece carbide tip spindle and interchangeable hardened anvils with ground threads. Micro-lapped anvil and spindle faces, perforated frame with enamel finish. Supplied with standards, ratchet stop, positive locking clamp and supplied in a wooden or plastic (depending on size) storage case. Accuracy: Flatness: 0.6mm up to 300mm, 1.0mm up to 300 - 1000mm. Parallelism: (2L/100)mm (fraction rounded down.) Instrument Error: /-(4L/75)mm (fraction rounded up.) L maximum measuring length.

Series 104

Kennedy® Screw Plug Gauges

Made from the finest quality steel and are thoroughly hardened, stabilised and thread ground under strict quality control procedures ensuring a high quality product and optimum wear life.

Double Ended Go & No Go

Metric Fine - Class 6H Tolerance

Kennedy® Screw Ring Gauges

Made from the finest quality steel and are thoroughly hardened, stabilised and thread ground under strict quality control procedures ensuring a high quality product for optimum wear life.

Go

BSF - Medium Class Tolerance

Interchangeable Rod Type

These are lightweight, well balanced and rigid. Satin-chrome finish with hardened, ground and lapped measuring screw. Each micrometer of less than 300mm (12") is supplied with convenient handle to reach into deep holes. The set also includes spacing collar, a series of precision measuring rods and a dull chrome plated micrometer head. Spacing collars are designed for making up for the limited stroke of the micrometer head. Each rod marked with length. Easily reset - adjustment positive and permanent. Anvil is made from high grade steel, hardened, precision ground, micro-lapped and adjustable. Spanner wrench supplied with each micrometer. Accuracy: Instrument Error: /-(6L/50) mu m; L maximum measuring length

Series 141