Cup Type (1282)

For easy and rapid single handed ignition of welding and cutting torches.

Euro Connection Torches

With high performance "Ergo" style handles. Supplied complete with liner and standard size tip. Model MB501DE is only for use with water cooling units (see also page7). Additional styles and full range of spares are available on request.

Kennedy Welding Accessories

Kennedy PVC welding curtains comply with EN1598 to block out welding light. The curtains have snap-fasteners on both sides to allow several to be joined together to create the desired width.

Supplied with reinforced holes on the upper edge and steel suspension rings.

PVC Welding Curtains

All Kennedy PVC welding curtains are made of a pliable, self-extinguishing PVC material with a flash point of 320-390C.

Conform to: EN1598 for welding (fulfilling requirements on transmittance, reflectance, UV-stability and resistance to ignition).

Supplied with steel curtain rings.

Available in a range of sizes and colours.

Spare Tips for Microset

Replacement tips to suit Microset (CTL-885-5502M).

Binzel Mig Torch Accessories

Also compatible with Parweld torches.

Contact Tips

Process & Heating Nozzles

200mm neck for acetylene nozzles.

Neck

Process & Heating Nozzles

Fully compatible with most heavy duty welding shanks and blowpipes. Including 1144, 1143, 2010, Saffire 5, 4, 3, NM250, NM400, Citogas HDT200, NMC200. Size 13 suitable for Saffire 4 and 3 only.

Acetylene Gouging Nozzles - A-GNM

Oxygen/Propane Cutting Kit

An oxygen & propane cutting kit capable of cutting up to 300mm (12”).

Contents:
18” - 90º nozzle mix cutting blowpipe.
Single stage 10bar/150psi oxygen plugged regulator.
Single stage 4bar/58psi propane plugged regulator.
Oxygen thermal in-line flashback arrestor.
Fuel gas thermal in-line flashback arrestor.
Pnm short nozzles.
Nozzle cleaners.
Cup type spark lighter.
Drop forged combination spanner.
Cup goggle 2" round shade 5 - EN166 & EN175.
Red plastic carry case.
*Requires separate hose set.

040951

Solent Flaw Detector Inspection System

Fast reliable method for visually inspecting and spot-checking surfaces of welds, exotic alloys or standard metals, highly stressed structural members, critical castings, shafts, gears, spindles, and any other hard part where identification of surface flaws is essential. Detects flaws such as cracks, pin holes, welding laps and porousness either during manufacture or on site. A three part system. SFD-501C is a cleaner. SFD-502C is a dye penetrant. SFD-503C is a developing fluid that reacts with the dye in SFD-502C to show small cracks in the weld. Each part supplied in an ozone friendly 500ml aerosol.

Flaw Detector Developer

White film to highlight any faults which have been detected when using Flaw Detector Penetrant. The product should be removed using Flaw Detector Cleaner Spray once cracks have been found and marked.

Parweld Mig Torch Accessories

Also compatible with Binzel Torches.