Anvils, Indentors & Test Blocks

To suit Oxford hardness tester.

V-Notch Anvil

Oxford Precision? Vee Blocks

Are matched and numbered pairs of closed grained iron castings accurately machined. Precision 90 vee blocks. Supplied as a pair.

Oxford Precision™ Granite

Precision granite products are manufactured to the highest quality standards to provide an accurate surface from which final measurements can be taken. More dimensionally stable than steel or cast iron, with a low thermal expansion co-efficient. Does not burr, is corrosion free and easy to maintain.



Accurate bases which are used for mounting sensitive measuring, mechanical & electronic equipment. Manufactured to BS817. Supplied with calibration certificate.

Oxford Precision Digital Indicator

Oxford Precision digital indicators feature large easy to read LCD displays. IP54 protection against dust ingress and fluid splash. Large responsive buttons that convert from inch/metric, zero reset at any point of the spindles travel. Auto power off after five minutes when not in use.

IDS Digital Indicator

IDS Digital Indicator Specification
Resolution: 0.01mm/0.0005"
Measuring range: 0 to 12.7mm/0.5"
The response speed: 0.5m/s.
Power: 1 x 1.5v silver oxide battery (SR44)
Operating temperature: 0°C to 40°C
Storage temperature: -20°C to 70°C
Relative humidity: @ 80%

Oxford Precision™ Vernier Bevel Protractor

Suitable for measuring and marking out angles. Fully hardened and ground stainless steel. Bevelled blade ends. Scale plate is graduated 0° - 90° - 0°, in both directions through
360°. Magnifying lens for easy reading of Vernier scale to 5 minutes of degree (1/12th of a degree).

Easy Read Dial Gauges Plunger Type

Matt finish chromed housings and black oxidised limit hands. Shockproof mechanism. Fitted with 1/4" inside diameter stem. Manufactured to BS 907.



58mm (2 1/4") Dial Diameter

Oxford Precision™ External Micrometers

With enamelled frame and tungsten carbide tipped anvils. High quality fitted metal case with adjusting spanner. Sizes 25-50mm/1-2" and over supplied with setting standard. All supplied in a high quality fitted metal case. Manufactured to BS 870.

Metric

Micrometer Setting Standards

For setting external micrometers, calipers etc. to zero, providing accurate repeatability of measurements. Flat, lapped measuring ends with fitted heat insulation block.Manufactured to BS 870.

167 Series (Micrometer NOT included)

Oxford Precision™ Interchangeable Anvil Micrometer

Carbide tipped spindle faces. Hardened and ground anvils. Supplied in metal case with adjusting spanner. 4 anvils and 3 setting standards. Accuracy: plus/minus (4 plus L/75)mm. Measuring Faces Flatness: plus/minus 0.6mm. Parallelism: plus/minus (2 plus L/100)mm.

Oxford Precision™ Dial Indicating Bore Gauges

Suitable for rapid, accurate measurement of size, concentricity, wear, taper, etc., in a wide range of bores. For workshop and inspection use. All models have one fixed and one moving anvil and a self-adjusting centre shoe. A datum point' can be set by using a setting ring of a known diameter or a micrometer. Zero' the gauge to this datum point by rotating the bezel to align zero' with the indicator. To check a bore is within tolerance, the limit hands can be fixed as required. All anvils are spring loaded to expand into the bore. For accurate reading ensure the stem of the gauge is parallel to the axis of the bore. This can be checked by 'rocking' the gauge back and forth until the smallest diameter is found. All models have interchangeable anvils to cover a range of bore sizes.