Kennedy® Carbide Burrs

Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel etc. up to HRC65 hardness. Operating speed range is 6000-40000rpm.

Cylindrical Ball Nosed

Cut 3 - Rapid Cut
For use on softer non-ferrous and plastic materials i.e. aluminium, fibreglass, plastics, hard rubber and zinc alloy.

Kennedy® Oilstones

The Kennedy® sharpening stone set contains a selection of medium grit aluminium oxide and silicon carbide stones, to cover the majority of sharpening applications. Supplied in a protective wooden case.

Six Piece Sharpening Stone Set

All of the sharpening stones are 100mm in length, medium grit supplied in both aluminium oxide and silicon carbide.
2 square.
2 three square.
2 round.Contents.

Kennedy® Economy Emery Cloth

The emery abrasive particles are bonded by a high strength glue to a flexible J-weight blue twill backing cloth. The backing cloth allows the abrasive sheet to conform to the shape of the item being worked on, ensuring the abrasive action is always where you require it. Suitable for general-purpose, light duty workshop use.

Rolls

Roll size: (W)38mm x (L)50 Metres. Available in several grades.

Kennedy® Pin Spanners for Angle Grinders

Several types available. Weight 110g.

Pin Spanner

To suit Kennedy® M14 pads and most 180/230 electric grinders.
Pitch: 35.
Pin diameter: 5.0.

Kennedy® Aluminium Oxide Cloth

Superflex Aluminium Oxide is resin bonded over resin on a very flexible J-weight blue twill cloth. Moisture resistant and electrostatically coated for polishing flat and contoured surfaces of most materials.

Rolls

Roll size: (W)50mm x (L)50 Metres. Available in several grades.

Kennedy® Router Cutters

General purpose tool suitable for profiling, rebating and through slotting. Plunge cut when on the move.

Two Flute Straight Plunging Bits

Kennedy® M2 Multi-Tooth Milling Cutters

Proven value and success based upon the low energy required to cut more holes accurately with extended tool life. The cutter is designed to enable a faster feed rate with lower cutting resistance, resulting in consistency of finish and tolerance.

Long Series

Shank dia.: 19mm/3/4".
Depth of cut: 50mm.
Bore: 6mm.
Overall length: 85mm.

Kennedy® Sharpening Stones

Aluminium Oxide man-made abrasive which is extremely tough enabling high speed penetration of high tensile materials without causing excessive fracturing. This resistance to fracturing makes it a versatile material suitable for general sharpening and honing applications.

3 Square Aluminium Oxide

A range of tough general-purpose sharpening stones able to give keen, even cutting edges on all straight edge cutting tools. Consistent and uniform cutting edges ensure fast cutting and longer tool life.

Kennedy® Sharpening Stones

Aluminium Oxide man-made abrasive which is extremely tough enabling high speed penetration of high tensile materials without causing excessive fracturing. This resistance to fracturing makes it a versatile material suitable for general sharpening and honing applications.

3 Square Aluminium Oxide

A range of tough general-purpose sharpening stones able to give keen, even cutting edges on all straight edge cutting tools. Consistent and uniform cutting edges ensure fast cutting and longer tool life.

Kennedy® 8 Piece Industrial Wire Brush Set

All supplied in clear bag with header.

Industrial Wire Brush Set (8 Piece)

Contents: (1 of each)
Shaft mounted circular brushes: 30 x 12, 50 x 20, 80 x 20.
Flat end de-carbonising brushes: 12 x 20, 24 x 25.
Pointed end de-carbonising brushes: 12 x 20 and 24 x 25.
Shaft mounted cup brush: 50 x 50.