Devcon "5 Minute" Epoxy Adhesive

Clear, permanent non-shrinking bonds. Bonds metals, glass, ceramics, concrete and wood. Works down to -40C when cured. Max Operating Temperature: 93C. Pot Life: 4 minutes. Mix Ratio: 1:1.

Devcon 2-Ton Clear Epoxy Adhesive

Produces strong, rigid bonds on metal, ceramics, wood, concrete, glass or combinations. Fills poorly mated surfaces and cures without shrinking with good impact strength.

Devcon 50ml Devweld 530

Rapid curing multi-purpose toughened structural methacrylate adhesive which produces superior load bearing bonds to engineered plastics, metals, ceramics and many other difficult substrates. Minimal surface preparation. Resistant to weathering, humidity and wide variations in temperature.

Stainless Steel Putty (ST)

Stainless steel filler for repairs. Used for rust-free patching and rebuilding. Bonds to ferrous, non ferrous metals and concrete. FDA approved. Max Operating Temperature: 121C.Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Flexane Liquid

Good for abrasion/tear resistant linings. Protects against vibration, shock & wear. Cost-efficient moulds (self-levelling).



Flexane 80: Shore 80, some flexibility. Max Operating Temperature: 82C. Pot Life: 30 minutes. Mix Ratio: 3.33:1.

Floor Patch

Bonds to new or old concrete producing a walkable surface in eight hours. Resistant to chemicals and heat up to 120C.

Plastic Steel Putty (A)

Steel filler. Bonds to metals, concrete, and some plastics. Resistant to rust, oil, petrol, water and chemicals. Machinable. Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Devcon 2-Ton Clear Epoxy Adhesive

Produces strong, rigid bonds on metal, ceramics, wood, concrete, glass or combinations. Fills poorly mated surfaces and cures without shrinking with good impact strength.

Devcon "5 Minute" Epoxy Adhesive

Clear, permanent non-shrinking bonds. Bonds metals, glass, ceramics, concrete and wood. Works down to -40C when cured. Max Operating Temperature: 93C. Pot Life: 4 minutes. Mix Ratio: 1:1.

Tooling & Production Epoxies

Devcon high performance tooling and production epoxies provide a fast and economical method of manufacturing moulds, patterns and tools. They may be machined, drilled and tapping using conventional machine tools, while their properties allow accurate and detailed reproduction when cast over existing models.

Plastic Steel Liquid

Fast-curing, self levelling for low-cost moulds and dies.Reproduces fine detail.Excellent surface finish.Machinable to close tolerances.
Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.