Plastic Steel Putty (A)

Steel filler. Bonds to metals, concrete, and some plastics. Resistant to rust, oil, petrol, water and chemicals. Machinable. Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Devcon 50ml Devweld 530

Rapid curing multi-purpose toughened structural methacrylate adhesive which produces superior load bearing bonds to engineered plastics, metals, ceramics and many other difficult substrates. Minimal surface preparation. Resistant to weathering, humidity and wide variations in temperature.

Plastic Steel 5-Minute Putty (SF)

Steel filled, fast curing epoxy putty for durable emergency repairs. Rust resistant. Bonds to steel, iron, aluminium, brass and concrete at temperatures as low as 4C. Max Operating Temperature: 93C. Pot Life: 5 minutes. Mix Ratio: 1.7:1.

Stainless Steel Putty (ST)

Stainless steel filler for repairs. Used for rust-free patching and rebuilding. Bonds to ferrous, non ferrous metals and concrete. FDA approved. Max Operating Temperature: 121C.Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Magic Bond

A two colour stick which seals leaks and repairs gouges in steel, aluminium, wood, fibreglass, concrete and ceramics. Works on wet surfaces, can be painted, sanded, machined, tapped or drilled and is ready for use in 1 hour.
Max Operating Temperature: 121C.
Pot life: 10 mins

Flexane Liquid

Good for abrasion/tear resistant linings. Protects against vibration, shock & wear. Cost-efficient moulds (self-levelling).



Flexane 94: Shore 94, relatively rigid. Max Operating Temperature: 82C. Pot Life: 10 minutes. Mix Ratio: 2.19:1.

Devcon "5 Minute" Epoxy Adhesive

Clear, permanent non-shrinking bonds. Bonds metals, glass, ceramics, concrete and wood. Works down to -40C when cured. Max Operating Temperature: 93C. Pot Life: 4 minutes. Mix Ratio: 1:1.

High Speed Emergency Repairs Zip PatchTM

Adhesive impregnated patch. For repairs to pipes, tanks, containers, etc. Hardens at room temperature to form a tough waterproof finish in minutes. Bonds to most common substrates. Max Operating Temperature: 93C.

Tooling & Production Epoxies

Devcon high performance tooling and production epoxies provide a fast and economical method of manufacturing moulds, patterns and tools. They may be machined, drilled and tapping using conventional machine tools, while their properties allow accurate and detailed reproduction when cast over existing models.

Plastic Steel Liquid

Fast-curing, self levelling for low-cost moulds and dies.Reproduces fine detail.Excellent surface finish.Machinable to close tolerances.
Max Operating Temperature: 121C. Pot Life: 45 minutes. Mix Ratio: 9.0:1.

Devcon "5 Minute" Epoxy Adhesive

Clear, permanent non-shrinking bonds. Bonds metals, glass, ceramics, concrete and wood. Works down to -40C when cured. Max Operating Temperature: 93C. Pot Life: 4 minutes. Mix Ratio: 1:1.