Micrometer Setting Standards

For zero adjustment of outside micrometers. Accuracy: Flatness: within 0.3 mu m. Parallelism: within 2 mu m

167 Series (Micrometer NOT included)

Large Diameter Type - 36.2mm Diameter Face

Large dial face for easy reading with the installed 2mm (.08") diameter point carbide tipped. These indicators are ruggedly housed within a satin chrome finished case. Bezel and dial are adjustable for easy zero setting with fully jewelled movements. Automatic reversible contact point is adjustable through 240. The precision miniature pivot bearings give a frictionless movement of the contact point. One piece bezel of crystal design ensures resistance to water and dust.

Series 513

Standard Type - Clock Only

Pocket Type - 32mm Diameter Face

9.5mm body for narrow lands between shoulders or in a bore. With jewelled bearings and precision miniature pivot bearings for almost friction-free movement of the contact point. Contact point is reversible by lever allowing measurement of the top or bottom surface of any workpiece. Bezel and dial face are fully adjustable.

Series 513

Dial Indicators - 41mm Diameter Face

Jewelled Type with Limit hands and Rev. Counter

Series 1

Micrometer Setting Standards

For zero adjustment of outside micrometers. Accuracy: Flatness: within 0.3 mu m. Parallelism: within 2 mu m

167 Series (Micrometer NOT included)

Series 550

Inch/metric conversion. Zero set at any point. SPC data output. Round measuring faces for accurate ID measurement. Power supply battery 1x SR44
Order Code EDI- 904-4000K supplied.
Resolution: 0.01mm/0.0005”.

Mitutoyo Single Rod Depth Micrometers

Single Rod Type with bases hardened, precision ground and micro-lapped. All other surfaces are satin-chrome finished. The screw is also precision ground and lapped. Ratchet stop. Spanner wrench with each micrometer. Accuracy: Instrument Error: /-3mm. Flatness of reference face (bottom face of base) 1.3mm for 60mm/2.5" base. 2mm for 100mm/4" base.

128 Series

Satin Chrome Finished Frame

Designed for measuring grooves, recesses and shoulders located inside a bore. They measure not only thickness and spacing of grooves, but also measure from an edge to a land, or from shoulder to groove. Spindle hardened and precision ground, with micro-lap finish on measuring face. Every thousandth is numbered for easy reading. To measure: Width of groove, Width of Land. To determine: Location of Groove, Depth of bottom of groove. Accuracy: Parallelism: 10 mu m. Instrument Error: /-10 mu m. Graduation: 0.01mm 0.001"

Series 146

Dial Calipers

Easy read dial suitable for use where a scale would be difficult to read. Satin chrome finish. Incorporates quadri feature.

Series 505

Large Diameter Type - 36.2mm Diameter Face

Large dial face for easy reading with the installed 2mm (.08") diameter point carbide tipped. These indicators are ruggedly housed within a satin chrome finished case. Bezel and dial are adjustable for easy zero setting with fully jewelled movements. Automatic reversible contact point is adjustable through 240. The precision miniature pivot bearings give a frictionless movement of the contact point. One piece bezel of crystal design ensures resistance to water and dust.

Series 513

Parallel Type - Sets