Heavy Duty Long Jaw

Longer jaws allow measurements to be taken where a standard caliper would not reach. Fine adjustment. Round measuring faces for accurate ID measurement. Satin chrome finish with clear easy read graduations.

Series 534

Enamelled Frame External Micrometers

Economy type with carbide tipped anvils. Accuracy: Flatness: 0.6mm for up to 300mm (12"), 1.0mm for up to 300-500mm (12-20"). Parallelism: 2L/100)mm (fraction rounded down). L maximum measuring length

103 Series

Ratchet Thimble

Sheet Metal Micrometers U-Type - Enamelled Frame

For gauging sheet metal, fibre etc with a deep throat frame. The measuring faces are carbide tipped. Accuracy: Graduation: 0.001" 0.01mm. Flatness: 150mm throat depth 0.6 mu m. 300mm throat depth 1 mu m. Instrument Error: 150mm throat depth /-4 mu m. 300mm throat depth /-5 mu m. Parallelism: 3 mu m

Series 118

57.4mm Diameter Face

Reverse reading Type (2902FE: Limit Hands, 2905-10 & 2923F-10: jewelled)

Series 2

Mini Micro Heads

The smallest micro-heads available from Mitutoyo. They are usually built into tools and instruments to enable the fine adjustment of small linear distances. Measuring face hardened. Without ratchet stop. Graduations: 0.01mm (.001"). Accuracy: /-5 mu m

Series 148

Heavy Duty Vernier Caliper

Thumb wheel and locknut with fine adjustment. Round measuring faces for accurate ID measurement. Satin chrome finish with clear easy read graduations.

Series 160

Metric & Imperial Reading Graduation: 0.02mm/0.001"

Digimatic Caliper

Inch/metric conversion. Zero set at any point. SPC data output. Round measuring faces for accurate ID measurement. Power supply - battery 1 off SR44. - Supplied

550 Series

Resolution 0.01mm/ 0.0005"

Enamelled Frame External Micrometers

Economy type with carbide tipped anvils. Accuracy: Flatness: 0.6mm for up to 300mm (12"), 1.0mm for up to 300-500mm (12-20"). Parallelism: 2L/100)mm (fraction rounded down). L maximum measuring length

103 Series

Ratchet Thimble

Enamel Finish Interchangeable Anvil Micrometers

With one-piece carbide tip spindle and interchangeable hardened anvils with ground threads. Micro-lapped anvil and spindle faces, perforated frame with enamel finish. Supplied with standards, ratchet stop, positive locking clamp and supplied in a wooden or plastic (depending on size) storage case. Accuracy: Flatness: 0.6mm up to 300mm, 1.0mm up to 300 - 1000mm. Parallelism: (2L/100)mm (fraction rounded down.) Instrument Error: /-(4L/75)mm (fraction rounded up.) L maximum measuring length.

Series 104

Dial Depth Gauges

Designed for measuring the depth of holes, narrow grooves and steps. Hardened steel base, ground and microlapped. Dial indicator attached to the base by a clamp screw and is easily interchangeable. Spindle lifting lever is maintained under spring pressure.

Series 7

Rods supplied: 0-200mm: 10, 20, 30 & 100mm 0-8": 1, 2 & 4"