Economy Applicator Guns

For all Araldite cartridges except 2014.

Z30 Corrosion Protection

Formulated to give an excellent degree of corrosion protection over long periods (up to 2 years). When applied, Z30 leaves a brown waxy film that will displace moisture and perform as a 'non-fling' lubricant. Ideal for long term protection of machinery, elevators, fork-lift trucks, underground installations, off-shore platforms etc.

Bostik 'C' Adhesive

Rubber to metal adhesive



Bostik ?C? adhesive is a black natural rubber, solvent borne general purpose adhesive. For use on rubber, linoleum, cork, felt, wood, metal and concrete. Heat resistant up to 70C and can be used in two way dry film contact application or one way wet film application.

British Standard 'O' Rings

NBR70 Rubber 'O' Rings
The most common and simplest types of seal with excellent sealing properties and durability.
Used in engines and gearboxes, also found in anything from
shower heads to an aircraft, garden hoses and pumps etc.,
They can be used as face to face gasket style
seals or as shaft seals and allow both rotary and
linear movement. They have a 70 Shore hardness
and an operating temperature range of -30C to
120C. Highly resistant to many chemicals,
petroleum, diesel, LPG etc.
All sizes to BS1806
Many other sizes and
materials in stock.

NBR70 Rubber 'O' Rings

Solent? Spill Response Kits

There are many situations where there is a need for a permanent supply of absorbents to be on hand. Solent Plus spill kits are a cost-effective answer to this requirement. Available in Maintenance, Oil-only and Chemical kits, they range in capacity from 10ltrs up to 240ltrs. They are packed with sufficient absorbents to cope with a spill up to the size shown.

15ltr Clip-Closed Carrier Spill Kit

Contents:
10 x pads.
1 x sock.
1 x disposal bag.

Rustoleum Combi Colour

Long lasting metal protection. Anti-rust primer and topcoat in one. Can be applied direct to rust or bare metal. High coverage: 10.5m2 per litre. Hides blemishes in one coat. Flexible film formula.

perma NOVA Lubricators - 130cc

Especially suited to single-point lubrication of roller and sliding bearings, sliding guides, open gears, gear racks, shaft seals and chains located in areas with considerable temperature variations (e.g. food industry) or where intrinsic safety is a requirement (as in the oil and gas industry). Dust-tight and protected against water jets.

British Standard 'O' Rings

NBR70 Rubber 'O' Rings
The most common and simplest types of seal with excellent sealing properties and durability.
Used in engines and gearboxes, also found in anything from
shower heads to an aircraft, garden hoses and pumps etc.,
They can be used as face to face gasket style
seals or as shaft seals and allow both rotary and
linear movement. They have a 70 Shore hardness
and an operating temperature range of -30C to
120C. Highly resistant to many chemicals,
petroleum, diesel, LPG etc.
All sizes to BS1806
Many other sizes and
materials in stock.

NBR70 Rubber 'O' Rings

Solent? Tough Stuff' Absorbents

Following on from the success of the Solent Plus absorbents are these all-new "ToughStuff" pads and rolls. Featuring a
unique three-layer construction, these products offer the very best of absorbent technology that is available today. Sandwiching a high loft filling of 100% polypropylene absorbent fibres there is a spun bond coverstock to the top for better wear resistance and a fine fibre coverstock to the underside for a lowlint finish that doesn't impede the speed of absorbency. Pads and rolls both utilise the same construction and are available in maintenance, oil-only or chemical grades with the same colour coding as all the other absorbents in the Solent Plus spill control range.

Maintenance Pad

Pack quantity: 20.
Size: 50 x 40cm.
Absorbs: 1.1 litres.

Impact Adhesive

Ideal for producing a strong bond on contact, without the need for jigs, clamps or weights.