Heavy Duty Liquid Measures

Chemical and oil resistant polyethylene liquid measures. Integral dispensing spout resistant to extreme weather conditions. Can be used in conjunction with dispensing spouts listed below.



Graduations: 1/2ltr - 1/4 & 1/2ltr, 1ltr - 1/4, 1/2, 3/4ltr, 2ltr - 1/2, 1, 1 1/2 & 2ltr, 3ltr - 1, 1 1/2, 2, 2 1/2 & 3ltr, 5ltr - 1, 2, 3, 4 & 5ltr

Hammer Shafts

Made from genuine hickory with a waxed finish. Manufactured to BS 3823.

Body Repair Kit Spares

Spares for hydraulic hand pumps

Double Ended Male Snap Connector

For Collision Repair Kit

Kennedy Specialist Automotive Tools

For the removal of diesel injection pumps from the following engines:

2.5TDS engines (BMW, Landrover, Vauxhall, OPEL)

DPP030 Diesel Injection Pump Puller

DPP030 Diesel Injection Pump Puller

Kennedy Cases - Accessories

NB: complete case is shown for illustration only. Case, contents and tools are not included.

Carbon Steel Non-Sterile Blades

Non-sterile, for use with no.4 type handle.

No.24

1/2" Square Drive Impact Socket Set

The sockets are manufactured from the highest quality chrome molybdenum steel which is clearly laser etched with the size for easy and rapid identification. Tough, impact-resistant carry case. Conforms to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

18 Piece Metric

Contents: Standard length: 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 24, 26, 27, 30 & 32mm.

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Half Round/ Bullnose Chisels

Used for cutting round bottomed grooves in steel such as oil grooves and also for 'roughing up' surfaces to be chipped by a flat chisel. The job is made easier by cutting grooves across the surface with this type of chisel then the raised portion can be easily chipped away with a flat blade.
Cutting angle 40 - 50 degrees to the vertical.

Kennedy Impact Socket Accessories

Kennedy impact sockets and accessories are manufactured from high quality chrome molybdenum steel with a black oxidised finish and are laser etched for easy size identification.

They are the ideal socket to use every day with an impact wrench to tighten or remove nuts or bolts.

They are available as ?? to 1?? square drive in a wide range of sizes.
Conform to DIN3129.

Sizes ?? and above feature a hole to accommodate a pin and ring to prevent accidental removal for added security.

Impact Socket Reducers

Kennedy® Butane Soldering Iron Tips

Interchangeable tips for use with Kennedy® BS075 soldering iron.