Pipe Bender - 022600

Suitable for producing bends in steel, copper or brass tubing up to 180.

Flaring Tool Set

Each set can be used to produce convex and double lap flares to SAE and DIN standards, accurately, reliability and efficiently on automotive brake and clutch pipes. Manufactured from hardened and ground steel, the formers are mounted on a revolving turret for easy selection with cam lever action for positive former location in the die. Automatic return.

27008

Pipe sizes: SAE single and double: 3/16", 1/4", 5/16, 3/8" & 1/2" 4.75, 6, 8, 10 & 12mm. DIN single: 4.75mm.

Flaring Tool Set

Each set can be used to produce convex and double lap flares to SAE and DIN standards, accurately, reliability and efficiently on automotive brake and clutch pipes. Manufactured from hardened and ground steel, the formers are mounted on a revolving turret for easy selection with cam lever action for positive former location in the die. Automatic return.

27002

Pipe sizes: SAE single and double: 3/16" & 4.75, 6, 8 & 10mm. DIN single: 4.75mm.

Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Mechanical Pullers - 2 Jaws - Industrial Reversible/Double Ended

The double ended reversible/double ended drop forged steel jaws, are heat treated for strength and durability. They can be used internally or externally.
083100:
Spread: 200mm.
Reach: 140mm.

Industrial Reversible/Double Ended

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Hydraulic Ram

Applies exceptional direct thrust with ease. Can ve used with bearings up to 140mm.

Separator & Puller Combination Set

Manufactured from forged alloy steel. Taper jaws allow the separator to be used where access behind the component is too restricted to use normal pullers.



155200 Makes four hydraulic pullers and one separator. In lockable metal case. Spread 50 to 150mm. Reach 50/100/150mm.

Mechanical Pullers - 2 & 3 Jaw Industrial Reversible/Double Ended

The double ended reversible/double ended drop forged steel jaws, are heat treated for strength and durability. They can be used internally or externally. 082805 - Spread: 200mm. Reach: 140mm.

"Multipull" Blind Housing Puller

For the removal of blind housing bearings without the need to dismantle machinery or remove the running shaft. Positive seating allows even tension on the inner and outer bearing rings reducing resistance. The stabilisers reduce sideways movement and self centres the puller. The three sets cover a range of ISO bearings, if there is no ISO reference on the bearing refer to the puller spread and adaptor.



098000 - ISO designation: 6004-6010, 6004-6015. Reach: 125mm. Adaptor diameter: 5.5 - 8mm.098100\t - ISO designation: \t6299-6205, \t6200-6211 & 6212-6222. Reach: 415mm. Adaptor diameter: 5.5 - 12.5mm.098200\t - ISO designation: \t6300-6302 Reach: 490mm. Adaptor diameter: 16 - 31.75mm.