"Multipull" Blind Housing Puller

For the removal of blind housing bearings without the need to dismantle machinery or remove the running shaft. Positive seating allows even tension on the inner and outer bearing rings reducing resistance. The stabilisers reduce sideways movement and self centres the puller. The three sets cover a range of ISO bearings, if there is no ISO reference on the bearing refer to the puller spread and adaptor.



098000 - ISO designation: 6004-6010, 6004-6015. Reach: 125mm. Adaptor diameter: 5.5 - 8mm.098100\t - ISO designation: \t6299-6205, \t6200-6211 & 6212-6222. Reach: 415mm. Adaptor diameter: 5.5 - 12.5mm.098200\t - ISO designation: \t6300-6302 Reach: 490mm. Adaptor diameter: 16 - 31.75mm.

Oil Filter Remover

Die cast screw with non stretch steel band. The tool is looped over the filter and tightened, once the filter is gripped firmly it can be removed. Suitable for one handed use in areas of confined access.

Steel Loop Oil Filter Removers

Bearing Separator & Puller Sets

Bearing separator with two interchangeable thin jaw puller legs. Puller has a 75mm spread and reach. The separator has a maximum diameter of 55mm and a reach of 115mm.

Anti-Freeze Tester

For checking the percentage of ethylene glycol-based coolants in an engine cooling system. Shows lowest temperature in C to which the cooling system is protected.

Sykes-Pickavant Adjustable Oil Filter Remover

Manufactured from hardened steel. The geared jaws automatically tighten as the load increases to securely grip the filter for safe removal. For use with a 3/8" square drive ratchet wrench or 19mm open ended spanner.

Three Jaw Oil Filter Wrench

Cylinder Hone Stone Sets

Contain 3 x 100mm stones and 3 replacement cotter pins.

To suit 028100

Oil Filter Remover

Die cast screw with non stretch steel band. The tool is looped over the filter and tightened, once the filter is gripped firmly it can be removed. Suitable for one handed use in areas of confined access.

Steel Loop Oil Filter Removers

Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Hydraulic Pullers

Ram Extension Bars

Hydraulic Pullers

Ram Extension Bars