Hydraulic Pullers

Ram Extension Bars

Long Reach Mechanical Pullers - 2 jaw - Industrial Reversible/Adjustable

The points at which the jaws are attached to the pulling frame, are adjustable providing more pulling options.
083300:
Spread: 350mm.
Reach: 380mm.

Hydraulic Pullers

Have a simple, grease filled ram instead of the mechanical force screw. This produces more power easily & efficiently. The spring loaded plunger provides direct, non- twisting application of thrust safely.

2 and 3 Jaw Kit

Combination twin/triple leg puller kits. Complete with ram extension. 155000: Spread: 150mm. Reach: 150mm. Extension: 50mm. Contains components to make up 4 different pullers. In metal box.

Thin/2 Jaw Mechanical Pullers

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
086000 Spread: 75mm. Reach: 75mm.
086100 Spread: 150mm. Reach: 150mm.
086200 Spread: 150mm. Reach: 225mm.
086300 Spread: 150mm. Reach: 225mm.

Separator & Puller Combination Set

Manufactured from forged alloy steel. Taper jaws allow the separator to be used where access behind the component is too restricted to use normal pullers.



Set contains components to make five different puller/separator combinations: 10mm, 89mm reach three jaw internal or external puller. Thin jaw, two jaw puller internal or external. 55mm diameter separator.

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Thin/2 Jaw Mechanical Pullers

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
086000 Spread: 75mm. Reach: 75mm.
086100 Spread: 150mm. Reach: 150mm.
086200 Spread: 150mm. Reach: 225mm.
086300 Spread: 150mm. Reach: 225mm.

Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Thin/2 Jaw Mechanical Pullers

Manufactured from forged steel, with thin jaws for access where the clearance behind the component is limited.
086000 Spread: 75mm. Reach: 75mm.
086100 Spread: 150mm. Reach: 150mm.
086200 Spread: 150mm. Reach: 225mm.
086300 Spread: 150mm. Reach: 225mm.

Slide Hammer Assembly

For use with Sykes-Pickavant split coller type internal extractors. Hammer displacement 220mm.