Kennedy Hydraulic Bottle and Trolley Jacks

Kennedy Hydraulic bottle jacks have large cast iron bases with a steel housing and lift cylinder, that has an adjustable notched load saddle. Each jack is fitted with an overload protection valve. Two piece pumping handle also operates hydraulic release.

For use on a firm level surfaces. DO NOT work under the raised vehicle until another means of support, such as axle stands are in place

GS and TUV approved.

For axle stands see order codes: KEN-503-5520K and KEN-503-5530K.

Hydraulic Bottle Jacks

Model number: B337
Maximum load: 3 Metric Tonnes.
Height range: 194 to 372mm Min/Max.
Max saddle adjustment: 60mm.
Weight: 3.75kg.

(Load ratings are Metric Tonnes i.e. 1 tonne = 1,000kg).
Supplied with spare seals.

Spare Tips

To suit the T-Handle Circlip Tool

Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Hex Driver Impact Sockets 3/8" sq. dr.

Hexagon sizes: 4, 5, 6, 7, 8, 10 & 12mm. Conforms to DIN 3129

1" Drive Retaining Ring & Pins

To suit outer diameters: 46-58mm, 62mm and 78-86mm.

T-Handle Clamps

Manufactured from high strength ribbed girder section heat treated carbon steel for improved strength and rigidity when placed under working loads, with nickel and chrome plated corrosion resistant finish the drive screw and T-bar are chemically blacked. Sliding T-handle for easy clamping. The swivel ball joint clamp foot ensures the clamping forces are applied evenly.

1/4" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Metric

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Flat Chisel

Used by the engineering and building trades for cutting and chipping cold metals, brick work and stone. The angle of the cut edge should be 60 - 70, inclusive, but is dependant on the material to be cut. When cutting metal, the softer the material is, the more acute the cutting angle should be.

Magnetic Wing Cover

Designed to be used in the workshop to protect car wings when working. Manufactured from heavy duty vinyl with a soft backing to prevent any scratching or marking of paintwork when in use. The cover is held in place by magnets stitched into the material. Folds to a quarter of its length for storing.

Kennedy® Engineers' Squares

Manufactured from hardened and tempered steel. The edges are ground parallel to give the square an exact right angle on both the inside and outside of the stock and blade.
Supplied in a robust case.

300mm (12") Engineers' Square

Filler Applicator

100mm wide plastic spreader, suitable for the application of auto body filler.