Valve Spring Compressor

Suitable for small to medium sized petrol and diesel engines. Cam action ensures the valve is gripped parallel to avoid distortion. Rapid jaw adjustment T bar with precision screw thread adjustment.

Medium Duty

660210: Straight jaw. Throat depth 150mm660220: Straight jaw. Throat depth 140mm660430: OHC. Throat depth 158mm

Sykes-Pickavant Medium Duty Ball Joint Separators

Manufactured from hardened steel with tough durable epoxy coating. The lever can be set to one of it's four positions simply by releasing the pivoting pin. The tapered slim fork allows easy access. Suitable for use on most car and light commercial ball joints. Throat depth: 080500 - 30mm. 080700 - 36mm.

Cylinder Hone Stone Sets

Contain 3 x 100mm stones and 3 replacement cotter pins.

To suit 028100

Internal Extractor Kits

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Valve Spring Compressor

Suitable for small to medium sized petrol and diesel engines. Cam action ensures the valve is gripped parallel to avoid distortion. Rapid jaw adjustment T bar with precision screw thread adjustment.

Heavy-Duty

039500: Straight jaw. Throat depth: 240mm

Hydraulic Hose Clamp

Spring loaded, clamps brake and fuel hoses to allow brake/clutch slave cylinders to be disconnected or removed with the minimum of fluid loss.

Sykes-Pickavant Hydraulic Ball Joint Separator

Manufactured from hardened steel with tough epoxy coating. Tapered fork for easy access. Hydraulic ram allows up to 8 tonnes of force to be applied. Jaw opening: 70mm. Throat width: 36mm. Throat depth: 50mm.

Brake and Fuel Line Clamp

Lightweight, non-conductive, glass reinforced nylon. Particularly useful in body repair shops where clamps need to be left on brake lines for extended periods.

Slide Hammer Assembly

For use with Sykes-Pickavant split coller type internal extractors. Hammer displacement 220mm.

Angular Torque Gauges

For tightening components to a specific torque. Easy read non-reflective graduated surface. 1/2" square drive.

Torque Range: 0-360Nm

For further specification on this product please see the attached PDF under the additional information tab.