Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Hydraulic Pullers

Ram Extension Bars

Tyre Tread Depth Gauge

Vehicle Inspectorate approvoed for MoT testing. Pocket sized, complete with clip and clear, easy to understand scale for fast tyre tread depth checks.

Cylinder Hone

Suitable for use with electric or air power drills. To hone and deglaze cylinder bores. The flexible drive shaft allows for easy alignment within the cylinder. Supplied complete with 220 grit stones.

Hydraulic Ram

Applies exceptional direct thrust with ease. Can ve used with bearings up to 140mm.

Sykes-Pickavant Coil Spring Compressor

For use on Macpherson struts to remove coil springs safely and easily. Overall length: 365mm.

Sykes-Pickavant Adjustable Oil Filter Remover

Polyester web strap with steel tightening shank. The shank has a 13/16" external hex and a 1/2" internal square drive. Suitable for removing oil, fuel and water filters, gripping hubs and brake drums, removing exhausts etc. The compact design allows use in confined spaces.

Strap Type Oil Filter Remover

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

5-Piece Trim Remover Set

5 piece set of angled lever tools designed for the safe and undamaged removal of trim and trim stud panels.
Manufactured from Hi-tech resilient plastic that avoids marking and scratching to polished metal, wood or leather trims.

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.