"Multipull" Blind Housing Puller

For the removal of blind housing bearings without the need to dismantle machinery or remove the running shaft. Positive seating allows even tension on the inner and outer bearing rings reducing resistance. The stabilisers reduce sideways movement and self centres the puller. The three sets cover a range of ISO bearings, if there is no ISO reference on the bearing refer to the puller spread and adaptor.



098000 - ISO designation: 6004-6010, 6004-6015. Reach: 125mm. Adaptor diameter: 5.5 - 8mm.098100\t - ISO designation: \t6299-6205, \t6200-6211 & 6212-6222. Reach: 415mm. Adaptor diameter: 5.5 - 12.5mm.098200\t - ISO designation: \t6300-6302 Reach: 490mm. Adaptor diameter: 16 - 31.75mm.

Angular Torque Gauges

For tightening components to a specific torque. Easy read non-reflective graduated surface. 1/2" square drive.

Torque Range: 0-360Nm

For further specification on this product please see the attached PDF under the additional information tab.

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Bearing Separator & Puller Sets

Bearing separator with two interchangeable thin jaw puller legs. Puller has a 75mm spread and reach. The separator has a maximum diameter of 55mm and a reach of 115mm.

Hydraulic Pullers

Ram Extension Bars

Hydraulic Pullers

Ram Extension Bars

Sykes-Pickavant Adjustable Oil Filter Remover

Polyester web strap with steel tightening shank. The shank has a 13/16" external hex and a 1/2" internal square drive. Suitable for removing oil, fuel and water filters, gripping hubs and brake drums, removing exhausts etc. The compact design allows use in confined spaces.

Strap Type Oil Filter Remover

Brake Bleeder

One man operation, the non-return valve ensures air does not return back into the system.
Capacity: 500ml.

Petrol Compression Tester Set

Large 83mm diameter easy to read dual scale \tgauge 0 - 20 bar with shock proof case and flexible 305mm rubber connecting hose with M14 and M18 thread, seven flexible rubber connecting adaptor hoses with brass screw couplings. Pressure release valve enables repeated cylinder testing without removing the cylinder. Supplied complete in an impact resistant service case.

Valve Spring Compressor

Suitable for small to medium sized petrol and diesel engines. Cam action ensures the valve is gripped parallel to avoid distortion. Rapid jaw adjustment T bar with precision screw thread adjustment.

Medium Duty

660210: Straight jaw. Throat depth 150mm660220: Straight jaw. Throat depth 140mm660430: OHC. Throat depth 158mm