Grease Nipple Kit

Contents
Straight: 1/4" BSP, 1/8" BSP, M8 x 1.25 & 1/4" BSF
45: M8 x 1.25 & M10 x 1.50
90: 1/4" BSF

Hexagon Ball Driver Set - Inch

8 Piece set. Hardened alloy steel blades. Fluted driver handles. Can be used at angles up to 25. Contents (one of each): 1/16", 5/64", 1/8", 9/64", 5/32", 3/16", 1/4" and 3/8".

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Medium & High Tensile Cutters

Compound action magnifies the pressure applied to the handle. Ensures a concentration of force between the jaws.

Centre Cut

Manufactured from drop forged hardened chrome vanadium steel. Ideal for cutting both flat and round section steels. Hardened carbon steel clipper cut jaws on 12", 18" and 24". High tensile 24" also available with end cut pattern. The 30", 36" and 42" come with centre cut pattern jaws. Tubular steel handles with cushion grip for maximum operator comfort. Conform to DIN 2076.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

1/4" AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Hexagon

Open Jaw Spanners

Made from forged and hardened steel. Conform to DIN 895.

Double Ended

Reversible Ratchet Ring Wrenches

For use where access is limited. With a built-in ratchet mechanism to provide speed and a reversible action which can be achieved by depressing the reversing lever or by simply turning the wrench over. All ratcheting ring wrenches are manufactured from chrome vanadium steel bi-hex rings.

25 Offset

Metric *Single hexagon

Double-Ended Ring Spanners

Made from chrome vanadium steel with a satin finish body and highly polished heads, with double ended closed jaw bi-hexagon offset. Conform to DIN 838, BS 192 : 1982 & BS 3555 : 1998.

A/F

Rafter's Square

Manufactured from hardened and tempered ground steel. Graduated to 2mm on one side and 1/8" and 1/16" increments on the other. In hands of a skilled carpenter the simple rafters square becomes an indispensable calculating device of immense capacity. Enabling the carpenter to easily determine the length of any common, hip, valley or jack rafter for any pitch of roof. To make the proper cuts, top and bottom as well as slide or cheek cuts for any rafter.